S250 Bobcat Loader
OI-36 Operation & Maintenance Manual
ATTACHMENTS AND BUCKETS (CONT’D)
Hand Lever Bob-Tach - Removing The Bucket Or
Attachment
Lower the lift arms and put the attachment flat on the
ground.
Raise the seat bar, unfasten the seat belt, set the parking
brake and exit the loader.
If the attachment is hydraulically controlled, lower or
close the hydraulic equipment. You may need to release
hydraulic pressure before disconnecting the quick
couplers (See Releasing Hydraulic Pressure (Loader and
Attachment) on Page OI-19).
WARNING
Before you leave the operator’s seat:
• Lower the lift arms, put the attachment flat on the
ground.
• Stop the engine.
• Engage the parking brake.
• Raise seat bar.
• (Foot Pedal Controls) Move pedals until both
lock.
• (Advanced Control System - ACS) Move the
hydraulic controls to the NEUTRAL POSITION to
make sure that both lift and tilt functions are
deactivated.
The seat bar system must deactivate the lift and tilt
control functions when the seat bar is up. Service the
system if hand controls do not deactivate.
• (Selectable Joystick Control - SJC) Move the
joysticks to the NEUTRAL POSITION to make
sure that travel and hydraulic functions are
deactivated.
The seat bar system must deactivate these functions
when the seat bar is up. Service the system if
controls do not deactivate.
W-2463-0603
Figure OI-67
Pull the Bob-Tach levers [Figure OI-67] all the way up.
WARNING
Bob-Tach levers have spring tension. Hold lever
tightly and release slowly. Failure to obey warning
can cause injury.
W-2054-1285
Enter the loader.
Perform the PRE-STARTING PROCEDURE (See
PRE-STARTING PROCEDURES on Page OI-25).
Start the engine and release the parking brake.
Be sure the lift arms are all the way down. Tilt the
Bob-Tach forward.
Figure OI-68
Move the loader backward, away from the bucket or
attachment [Figure OI-68].
P-31240
P-31238
To Next Page
Loading...