How to stop connectors and lugs from overheating on my BOC Welding System?
If the connectors and lugs of your BOC Welding System are overheating, it might be due to loose or badly crimped connectors. Tighten all connectors and ensure they are properly crimped.
What causes no gas flow or continuous gas flow in a BOC Welding System?
If your BOC Welding System has no gas flow or the gas flows continuously, the gas valve may be faulty or sticking in the open position. You should test and replace the gas solenoid valve if needed.
Why does my BOC MIG 250C Welding System have erratic or no output control?
If your BOC Welding System has erratic or no output control, the switches might be damaged or incorrectly set for the application. Check the switches for damage and ensure they are set correctly.
What to do if the arc will not initiate on my BOC MIG 250C Welding System?
If the arc won't initiate in your BOC Welding System, it could be due to damaged, loose, or undersized cables and clamps. Inspect the earth cable and clamp for any damage, and ensure they are properly connected.
Details health risks associated with welding processes including UV rays, fumes, and gases.
Recommends appropriate personal protective equipment (PPE) for welding operations.
Provides critical safety measures to avoid electric shock during welding.
Outlines the user's obligations for safe operation and maintenance of the equipment.
Provides indicative welding parameters for different materials and processes.
Step-by-step guide for installing the MIG/MAG welding process.
Step-by-step guide for installing the MMA welding process.
Procedure for setting up the machine for MIG welding operations.
Procedure for setting up the machine for MMA welding operations.
General| Output Current Range | 30-250A |
|---|---|
| Welding Current Range | 30-250A |
| Weight | 52kg |
| Duty Cycle | 60% @ 250A |
| Input Phase | 3 |
To Next Page