What to do if heart rate is not displaying on Body Break Exercise Bike?
If the heart rate isn't displaying on your Body Break Exercise Bike, there are several potential causes: * The pulse wire might not be securely connected. Ensure the wires are properly plugged together. * The hand pulse may be defective, requiring a replacement. * The computer itself might not be working correctly, in which case it should be replaced.
Why no speed or distance displays on Body Break Exercise Bike monitor?
If speed or distance aren't showing on your Body Break Exercise Bike monitor, it could be due to a few reasons: * The sending unit might not be properly connected. Make sure it's securely plugged into the extension wire and the back of the computer. * The sending unit itself could be malfunctioning and need replacement. * The computer might be faulty, requiring a replacement.
Why is there no tension on my Body Break Exercise Bike?
If you're experiencing no tension on your Body Break Exercise Bike, it could be due to: * The motor cable or resistant cable not being connected. Ensure you securely connect the motor cable into the extension motor cable and the resistant cable. * The magnetic wheel not working properly. If this is the case, consider replacing the magnetic wheel.
How to stop grinding noise in Body Break Exercise Bike?
If your Body Break Exercise Bike is making a grinding noise, it could be due to: * A defective crank bearing. Consider replacing the crank bearings. * A defective idler pulley. Consider replacing the idler pulley. * A defective magnetic flywheel. Consider replacing the mag. flywheel.
What causes squealing in Body Break Exercise Bike?
If your Body Break Exercise Bike is squealing, it's likely due to the poly V-belt slipping. Try adjusting the poly v-belt to resolve this.
Instructions for attaching the front stabilizer to the main frame using bolts, washers, and nuts.
Connect the extension hand pulse wire and attach the rear seat tube to the main frame.
Attach the seat support tube and rear stabilizer to the rear seat tube with hardware.
Slide the seat bracket onto the rear seat tube and secure it with a quick release and bolt.
Attach handlebars to the seat bracket and connect the hand pulse wires.
Attach pedal straps to pedals and then attach pedals to the crank arms, noting left/right thread direction.
Install the upright and stationary handlebar, connecting various wires and securing with bolts.
General| Brand | Body Break |
|---|---|
| Model | 16116807 |
| Category | Exercise Bike |
| Language | English |
To Next Page
