21
7.1 General Instructions
WARNING
+ Do not make any improper changes to the equipment.
CAUTION
+ Damaged or worn components may affect your safety and the life of the equipment.
Therefore, immediately replace damaged or worn components. In such a case, contact the
contract partner. The equipment must not be used until it has been repaired. If necessary,
use only original spare parts.
ATTENTION
+ In addition to the instructions and recommendations for maintenance and care given here,
additional service and/or repair work may be necessary; this must only be carried out by
authorised service technicians.
7.2 Faults and Fault Diagnosis
The equipment undergoes regular quality controls during production. Nevertheless, faults or
malfunctions may occur. Frequently, individual parts are responsible for these disturbances, an
exchange is usually sufficient. Please refer to the following overview for the most common
errors and how to correct them. If the equipment still does not function properly, contact your
contract partner.
Squeaking or
cracking noise
Loose or too tight screw
connections
Check screw connections or lubricate
Cracking in the
pedals
Loose pedals Tighten pedals
Machine is wobbling Machine is not levelled Align feet
Handlebar/saddle is
wobbling
Loose screws Tighten screws
Display does not
work
battery empty or loose
cable connection
Replace batteries or check cable
connections / power supply unit
No pulse display
+ Sources of interference
in the room
+ Unsuitable chest strap
+ Position of the chest
strap incorrect
+ Batteries empty
+ Remove sources of interference
(e.g. mobile phone, speakers, WLAN,
mover- and cleaning robot, etc.)
+ Use suitable chest strap (see
recommended accessories)
+ Reposition chest strap and/or
moisten electrodes
7 TROUBLESHOOTING, CARE AND MAINTENANCE
To Next Page
Loading...
