Page 4
Installation Instructions
1. Check that the mains water pressure does not exceed 450Kpa. (65psi). If the pressure is too
high, fit a pressure reducing valve to the water inlet before the water filter (a 350kpa Pressure
Limiting Valve is recommended).
2. Screw the legs on to the machine and adjust to the desired height and level.
3. Connect the braided hose and install the fittings.
Very important: Flush the water filter
4. Point the water filter into a bucket or a drain, and then turn on the water tap to flush the loose
carbon from the water filter (approximately 15 Litres of water).
5. Connect the braided hose between the water filter and the Coffee Machine water inlet using the
fittings.
6. Turn the water tap on and check for water leaks (stop leaks if any).
7. Make sure the power switch on the Coffee Machine is switched off.
8. Plug the coffee machine power cord into an appropriate power point and switch it on.
9. Push the Coffee Machine Main power switch on.
10. Refer General Care and Group Maintenance instructions found on the lid of machine and in this
manual.
To Next Page
