Page 5
Volumetric Touch Pad
Please ensure you have read the General Care Instructions first
Pre-infusion is when a jet of water is first sprayed onto your ground coffee prior to commencement of
the main brewing cycle. The objective is to enhance the flavour of the brew. As the experts advise,
there is also a minimum and maximum brewing time to optimise your flavour. Pre-infusion is most
commonly thought to be useful for the shorter deliveries of coffee.
The machine may already be in Pre-infusion mode. If not, you will need to set this up.
Pre-Infusion Set-up
1. Turn the machine off
2. Press and hold the
(short black)
3. Turn the machine back on
4. The lights will come on above the (short black) and (two short blacks) button. These will
be the only deliveries that will engage the Pre-Infusion mode.
5. Switch the power off and then on again. The lights on the Touch Pad display will not remain
on and the touch pad will be in operation mode with Pre-infusion.
Pre-Infusion removal
1. Turn the machine off
2. Press and hold the (long black) button
3. Turn the machine back on
4. The light will then come on above the (long black) button
5. Switch the machine off then turn it back on. Normal operation will now be resumed.
Programming Key / Continuous flow
To Next Page
