Bolens 12226 - User Manual

Questions and Answers

L
Lisa GentryJul 28, 2025
Why won't my Bolens 12226 engine start?
- M
  Michael NicholsJul 28, 2025
  There are several reasons why your Bolens Tiller engine might not be starting: * The spark plug wire might be disconnected; reconnect it. * The Engine Throttle Control Lever may be incorrectly set; put the lever in the START position. * The fuel tank could be empty; add fuel. * You might have stale gasoline; drain the old fuel and add fresh fuel. * The air filter(s) might be dirty; clean or replace the filter(s). * The spark plug might be defective or incorrectly gapped; inspect the spark plug. If none of these resolves the issue, you may need to consult an Engine Service Dealer for carburetor, throttle control, or fuel tank issues.
R
Ryan BartonAug 2, 2025
What to do if my Bolens 12226 engine runs poorly?
- S
  Shawn CantuAug 2, 2025
  If your Bolens Tiller engine is running poorly, consider the following: * Inspect the spark plug, as it may be defective or incorrectly gapped. * Clean or replace the air filter(s). * Replace stale gasoline with fresh gasoline. If these steps don't improve performance, the carburetor may need adjustment, or there might be dirt or water in the fuel tank, requiring assistance from an Engine Service Dealer. Also, the engine cooling system might be clogged.
N
Nicole HahnAug 6, 2025
What to do if my Bolens 12226 engine overheats?
- T
  Tommy LeeAug 6, 2025
  If your Bolens Tiller engine is overheating: * The engine cooling system might be clogged, so clean the air cooling area. * The oil level might be low; check and replenish as needed.
S
Sarah JonesAug 10, 2025
Why won't the wheels and tines turn on my Bolens 12226 Tiller?
- R
  Raymond LunaAug 10, 2025
  If the wheels and tines on your Bolens Tiller aren't turning: * Ensure proper use of the controls. * Check the forward clutch control cable; it may need adjustment. * Inspect the clutch belts for wear or breakage and replace if necessary. * Tighten the screw and check the key in the transmission pulley. Internal transmission wear or damage may also be the cause.
N
Nicholas MooreAug 14, 2025
Why do the tines turn, but the wheels don’t, on my Bolens Tiller?
- K
  Katelyn WrightAug 15, 2025
  If the tines turn, but the wheels don’t on your Bolens Tiller, it could be due to: * Missing wheel mounting hardware; replace the hardware. * A loose screw and key in the transmission pulley; tighten the screw and ensure the key is in place. It's also possible that there is internal transmission wear or damage, or that the wheel gear lever is not fully engaged.
J
James WeaverAug 19, 2025
Why do the wheels turn, but the tines don’t, on my Bolens Tiller?
- R
  Ronald MarshAug 19, 2025
  If the wheels turn, but the tines don’t on your Bolens Tiller, it might be because of: * Missing tine holder mounting hardware; replace the hardware. It's also possible that there is internal transmission wear or damage.
J
Jessica KnightAug 23, 2025
Why does my Bolens Tiller have poor tilling performance?
- J
  Jason JenkinsAug 23, 2025
  Poor tilling performance on your Bolens Tiller can be attributed to: * Worn tines. * Improper Depth Regulator setting. * Incorrect throttle setting. * Slipping belt(s).