Questions & Answers on Bread Baking Machi
Questions & Answers on Bread Baking MachiQuestions & Answers on Bread Baking Machi
Questions & Answers on Bread Baking Machines
nesnes
nes
Problem
ProblemProblem
Problem
Cause
CauseCause
Cause
Solution
SolutionSolution
Solution
You have not inserted the plug. The appliance or the display are
not functioning.
You have not switched the On/Off
switch (L) on.
Check the plug and the switch.
Smoke comes out of the baking
compartment or of the vents.
The ingredients stick to the baking
compartment or on the outside
of the baking tin.
Pull out the plug and clean the
outside of the baking tin or the
baking compartment.
The bread goes down in the
middle and is moist on the bottom.
The bread is left too long in the
tin after baking and warming.
Take the bread out of the baking
tin before the warming function is
over.
It is difficult to take the bread out of
the baking tin.
The bottom of the loaf is stuck
to the kneading peg.
Clean the kneading peg and shafts
after the baking. If necessary, fill
the baking tin with warm water for
30 minutes. Then the kneading
pegs can be easily removed
and cleaned.
Incorrect program setting Check the selected menu and the
other settings.
The START/STOP key was
touched while the machine was
working
Do not use the ingredients and
start over again.
The lid opened several timers
while the machine was working.
The lid is to be opened only if the
time left on the display is more
than 1:30 hours. Make sure that lid
was closed well after being
opened.
Long blackout while the
machine was working.
Do not use the ingredients and
start over again.
The ingredients are not mixed or
the bread is not baked correctly.
The rotation of the kneading
pegs is blocked.
Check that the kneading pegs are
blocked by grains, etc. Pull out the
baking tin and check whether the
drivers turn. If this is not the case,
send the appliance to the customer
service.
The appliance does not start. The
time acoustic signal goes off. The
display shows H:HH.
The appliance is still hot after
the previous baking procedure.
Press the START/STOP key
for 10 sec. until 1 3:00 (normal
program) appears. Pull out the
plug. Take out the baking tin and
leave it to cool at room
temperature. Then insert the plug
and start again.
To Next Page
Loading...
