14
Starting a
Starting a Starting a
Starting a rinse
rinserinse
rinse
program
programprogram
program
• The water supply must be opened up to the maximum pressure.
• Load the dishwasher baskets.
• Fill in the detergent.
• Press the POWER- button to switch on the appliance.
• Select the desired rinse cycle.
• Set available options (depending on model), if required.
• Press the START/PAUSE- button and the dishwasher starts.
Program change
Program changeProgram change
Program change
CAUTION:
CAUTION:CAUTION:
CAUTION:
A program change should be done only a short time after starting the program. Otherwise, maybe detergent
has been released and already drained rinse water.
• Press the START/PAUSE- button for several seconds to stop the running program.
• Select the desired program and start the new operation.
Forgot to add a dish?
Forgot to add a dish?Forgot to add a dish?
Forgot to add a dish?
WARNING:
WARNING:WARNING:
WARNING:
Open the door very carefully during operation, there is a risk of water squirting out.
Dishware can be added any time before the detergent dispenser opens.
• Press the START/PAUSE- button to stop the operation. Once the spray arms have stopped, you can open
the door completely.
• Add forgotten dishware and close the appliance door.
• Press the START/PAUSE- button, after approx. 10 seconds the operation will be continued.
At the e
At the eAt the e
At the end of program
nd of programnd of program
nd of program
CAUTION:
CAUTION:CAUTION:
CAUTION:
Allow the appliance to cool down a bit after the program has ended, before you open it. This avoids that steam
escapes that causing long-term damages to your furniture.
At the end of the rinse cycle will sound a series of signals; then the unit goes into standby mode.
Switch off
Switch offSwitch off
Switch off
• Switch the appliance off by pressing the POWER- button.
• Close the water supply!
• Remove the dishes after cooling (see "Unloading the dishwasher baskets").
• Leave the appliance door slightly open until the next rinse cycle to avoid odors.
• If the appliance is not in use for an extended period:
-
disconnect it from the power supply!