18
Problem
ProblemProblem
Problem
Possible cause / Action
Possible cause / ActionPossible cause / Action
Possible cause / Action
Detergent dispenser doesn’t
close properly
Clogged detergent residue is blocking the catch. Clean the catch.
Detergent left in dispenser Improper loaded dish is blocking the dispenser.
Unsatisfactory drying result Improper loading / too less rinse aid / dishes are removed too soon / wrong pro-
gram has been selected / use of cutlery with a low-quality coating
Error
Error Error
Error codes
codescodes
codes
With some malfunctions the appliance indicates the following error codes to warn you:
Program sequence indication is flashing
Program sequence indication is flashingProgram sequence indication is flashing
Program sequence indication is flashing
Possible causes
Possible causesPossible causes
Possible causes
Drying Water inlet malfunction.
Main rinse Possible overflow / leakage occurs.
Pre-rinse + Drying Button is pressed more than 30 seconds. If not by a person, there is
possibly water on the circuit board.
CAUTION
CAUTIONCAUTION
CAUTION:
::
:
• If overflow occurs, turn off the main water supply before calling an authorized technician.
• If there is water in the lower housing part due to an overfilling or a small leak, remove this water before
restarting the appliance.
NOTE:
NOTE:NOTE:
NOTE:
If a problem still persists after following the steps above, please contact your distributor or an authorized tech-
nician.
Technical Data
Technical DataTechnical Data
Technical Data
Electrical connection
Electrical connectionElectrical connection
Electrical connection
/
/ /
/ Water su
Water suWater su
Water sup
pp
pply
plyply
ply….
….….
….……...
……...……...
……...…………………………………….…………………………...………..
…………………………………….…………………………...………..…………………………………….…………………………...………..
…………………………………….…………………………...………..
Mains voltage: …………......…………………..………….…………………………..……………...……...220-240 V~
Mains frequency: ………………..…...…………………………………………………………………………......50 Hz
Power consumption: ………………………………………………………………………………..........1760-2100 W
Fuse protection: ………………………………………...…………………………………………..…...……….......10 A
Water pressure: ………………………………………………………………………………...……...…0.04 – 1.0 Mpa
Dimension H x W
Dimension H x WDimension H x W
Dimension H x W
x
x x
x D
DD
D
/
/ /
/ Weight...
Weight...Weight...
Weight...……...…………………………………………………………………………………..
……...…………………………………………………………………………………..……...…………………………………………………………………………………..
……...…………………………………………………………………………………..
Appliance size: …..…………………………………………………………………...……......…84.5 x 44.8 x 61.0 cm
Net weight: ………………………………………………………………………………..……………...approx. 33.0 kg
Available accessory
Available accessoryAvailable accessory
Available accessory…………….……...…………………
…………….……...……………………………….……...…………………
…………….……...…………………………………………………………………………………..
………………………………………………………………..………………………………………………………………..
………………………………………………………………..
Inlet hose safety system: …..………………………………………………………..…………….....Art.-No. 8900 400
The right to make technical and design modifications in the course of continuous product development re-
mains reserved.
To Next Page
Loading...
