Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the user instr uctions!)
Electric indicator on control panel (if pro vided) .
Check the rinse aid level
(On mo dels w ith water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles t he dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Turnonthewatertap,closethedoor.Themachinewillstartworkingafterabout10seconds.
Running the dishwasher
Switch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 mi n utes) before unload ing the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower b asket.
Changing the programm e
Add forgotten dish es in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Refer to the dishwasher loadin g instructions.
Press the Programm e Butto n until the selected programme lights up .
( See the section entitled Oper ationg instruc tion )āā
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 tim es, then stop.
Turn off the appliance using the On /Off Button.
If the appliance is switched
off during a wash cycle.
Op en t he do or car eful l y.
Hot st eam may esc ape
when the door isopened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Open t he door ,press the On/Off button to switch on the applian ce .
1.Open the doo r a little to sto p the dishwasher.
2.After the spray arm s stop working, you can open the d oor completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher w ill start running again after 10 seconds.
For detailed operating method read the co rresponding content on t he instructio n man ual.
1. A running cycle can o nly be modified if it has been running for a short time. O therwise the detergent
m ay have already been released and the water a lready drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the for more than 3 seconds to cancel the running programme.
3. Select a new programme.
4. R estart the dishwasher.
Programme Button
C
A
B
To Next Page
Loading...
