5
• Children
ChildrenChildren
Children under 3 years should be kept away, unless they are constant-
ly supervised.
• Children
ChildrenChildren
Children shall not play with the appliance.
• Cleaning and user maintenance
user maintenanceuser maintenance
user maintenance shall not be made by children,
children,children,
children, unless
they are older than 8 years and are supervised.
• Do not try to repair the appliance on your own. Always contact an au-
thorized technician. If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Unpacking the Appliance
Unpacking the ApplianceUnpacking the Appliance
Unpacking the Appliance
• Remove the appliance from its packaging.
• Remove all packaging material, such as foils, filler
and cardboard packaging.
• To prevent hazards, check the appliance for any
transport damage.
• In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE
NOTENOTE
NOTE:
::
:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter “Cleaning and Maintenance”.
Appliannce Equipment
Appliannce EquipmentAppliannce Equipment
Appliannce Equipment
Appliance Overview
Appliance OverviewAppliance Overview
Appliance Overview
1
11
1
Control panel 6
66
6
Condenser
2
22
2
Unit door/Bull’s-eye 7
77
7
Lint filter
3
33
3
Ventilation openings 8
88
8
Mains plug
4
44
4
Filter unit 9
99
9
Condensation tank
5
55
5
Maintenance cover
Installation
InstallationInstallation
Installation
WARNING:
WARNING:WARNING:
WARNING:
The appliance must not be connected to the mains
during installing. Otherwise there is da
dada
dan
nn
nger to life
ger to lifeger to life
ger to life or
electric shock hazard
electric shock hazardelectric shock hazard
electric shock hazard!
Appliance location
Appliance locationAppliance location
Appliance location
• The site should be located near the water inlet
and outlet, as well as near a properly grounded
power socket.
• Good ventilation around the appliance is required,
in order to dissipate the heat properly. Sufficient
clearance must be created for this purpose.
• The clearance to the front must be created so,
that the appliance door can open without being
impeded.
• Make sure that the floor on which the appliance is
installed, is even, heat-resistant and clean.
To Next Page
Loading...
