What to do if the frame is not raising when cut is finished on my Bomar Saw?
If the frame is not raising when the cut is finished on your Bomar Saw, it may be due to a wrongly adjusted bottom limit switch or an error in the hydraulic (pneumatic) ring. Check the bottom limit switch adjustment. Also, check the function of the magnetic valve, ensure the valve is closed, and verify the voltage of clamps and inductor.
How to troubleshoot cleansing of the saw band if it is not functional on Bomar Saw?
If the cleansing of the saw band is not functional on your Bomar Saw, it might be because the elastic wheel of the brush drive or the knurling of the driving wheel is worn-down, or the shaft of the brush drive is rusted. Replace the elastic wheel or the driving wheel as needed. Clean and oil the shaft of the brush.
What to do if the hydraulic aggregate cannot be started on my Bomar Saw?
If the hydraulic aggregate cannot be started on your Bomar Saw, the auxiliary contact on thermo-relay FA1 may be defective. Replace the defective contact on motor starter FA1.
What causes damage to the tooth system of the saw band on Bomar Saw?
Damage to the tooth system of the saw band on your Bomar Saw can be caused by backlash in gripping the lifting cylinder or a squeezed pin in the upper or downer holder of the lifting cylinder. Exchange complete upper or downer holder of lifting cylinder.
What to do if cooling is not active on my Bomar Saw?
If cooling is not active on your Bomar Saw, check for a lack of cooling agent and fill the tank if necessary. Also, check if the thermal relay is defective and change it if needed. Inspect the input hosepipe for breaks or obstructions, and cleanse the cooling system. Check the cooling pump protection and replace if defective. Finally, consider replacing the cooling pump if it is defective.
What causes the indicator of speed saw band to be not functional on Bomar Saw?
If the indicator of speed saw band is not functional on your Bomar Saw, it may be due to the sensor of speed not being adjusted, a defective display, or a wrong sensor. Adjust the sensor of speed, change the display or sensor.
To Next Page
General
