Bompani 96A - Semi-Automatic Cooking Duration; Using the Electronic Timer

10
switch (pan symbol on).
SEMIAUTOMATIC OPERATION WITH
COOKING DURATION
Set the cooking duration: at the end of the
countdown the oven switches off and a
buzzer sounds.
Example: it is 11:35 and you wish to oven
to stay on for 25 minutes starting from now.
Press the
▲
key until the display shows
’00:25, adjusting the value if necessary with
the
▼
button. The pan and bell symbols are
on. Turn the oven thermostat knob to the
temperature required and set the selector
switch on the chosen cooking mode: the
oven indicator lights and inside light illumina-
te and the oven comes into operation.
N.B.: The units of measurement used for the
cooking duration change depending on the
setting: initially the numbers on the display
show the minutes and the seconds, and in-
creases are in 10 seconds, until 99 minutes
and 50 seconds is reached. After this dura-
tion, the display changes and the numbers
show the hours and minutes, with increases
of 1 minute (from 1 hour and 40 minutes up
to a maximum of 10 hours).
N.B.: To reset the cooking duration keep the
▼
key pressed until zero is reached.
After 25 minutes the oven and the pan and
bell symbols turn off and the buzzer warns
that the cooking procedure has ended.
Press the “MODE” key to stop the buzzer
and restore manual operation. Then turn the
thermostat knobs and oven selector switch
to the off position.
BUZZER
The buzzer sounds for 7 minutes.
You can disable the buzzer (but not prevent
the oven from switching off) by pressing the
“MODE” key during the last 15 seconds of
the countdown.
Pressing the
▼
key without fi rst selecting a
function allows you to change the sound of
the buzzer. There is a choice of up to 3 dif-
ferent types of buzzer. The selected buzzer
type will sound for as long as the
▼
key is
pressed.
USE OF THE ELECTRONIC TIMER (Fig.
13)
This allows the start time and cooking duration
time to be programmed. If food does not need
to be watched, this timer can be selected even
when the user is absent. Soon after installation
and at any electrical supply cut-outs the display
fl ashes; the clock must then be synchronized
again to allow programming.
SETTING THE TIMER TO THE CURRENT
TIME
- The current time is set by pressing the 2
buttons (
COOKING TIME
and
STOP
) and the "+"
or "-" button at the same time. Any previous
programmes are cancelled and the
AUTO
symbol fl ashes.
NOTE: when the
AUTO
symbol is fl ashing the
oven cannot be used manually.
"+" AND "-" BUTTONS
- Pressing the "+" or "- "buttons makes time
go up or down at variable speed according
to how long the button is pressed for.
MANUAL USE
- Press the
MANUAL
button: the
AUTO
symbol
goes out (if fl ashing or permanently on) the
SAUCEPAN
symbol lights up and the oven can
be used by adjusting the thermostat knob and
the selector switch according to the instruc-
tions given in the manual.
AUTOMATIC OPERATION WITH END OF
COOKING AND DURATION TIMERS
- Let’s use an example: it is 9:25 am; you want
the oven to switch on at 11 am and switch off
at 12 pm (cooking time 1 hour).
- Press the
COOKING DURATION
button and
within 5 seconds press "+" button until it
shows 01.00, adjust using "-" button if nec-
essary. The
AUTO
and
PAN
symbols come on
permanently.
- Press the
END OF COOKING
button and within 5
seconds press "+" button until it shows 12.00.
The
PAN
symbol goes out but the
AUTO
symbol
remains permanently on.
- Move the oven thermostat knob to the desired
temperature, and the selector switch to the
required cooking method; the red warning
light comes on the oven light comes on and
For the user
AU