Bompani 96A - For the User; Igniting Hob Burners; Hob Burners with Safety Device; Safety Device Functionality

7
burning match towards the burner; IT MUST
NOT IGNITE.
Time needed to excite the magnet during igni-
tion: 10 seconds approx.
Automatic tripping time, after fl ame has been
turned off: not more than 90 seconds for hob
burners; not more than 60 seconds for oven
and grill burners.
I
MPORTANT:
Before doing any work inside the
cooker, disconnect the mains plug and shut the
gas tap.
Never use matches to check the gas
circuit for leaks. If a specifi c control device is
not available, foam or very soapy water can be
used.
When re-closing the hob, check that the
electrical wires of the spark plugs (if present)
are not close to the injectors, so that they can-
not run across them.
BEFORE LEAVING
Ignite all burners to ensure correct operation
of gas valves, burners and ignition. Turn gas
taps to low fl ame position and observe stability
of the fl ame. When satisfi ed with the appliance,
please instruct the user on the correct method
of operation. In case the appliance fails to
operate correctly after all checks have been
carried out, refer to the authorised service
provider in your area.
HOW TO USE THE COOKER
VENTILATION
All gas cooking appliances produce heat
and moisture in the rooms where they are
installed. Take care to ensure that the
kitchen is well ventilated; keep the ventilation
openings unobstructed or install an extractor
hood with fan.
In case of intensive or prolonged use, ad-
ditional ventilation may be required; open
a window, or increase the extractor fan
power.
IGNITING THE HOB BURNERS
- Press the knob and turn it anti-clockwise
until it reaches the
symbol on the control
panel (maximum fl ame position);
- at the same time, move a burning match
towards the burner head;
- to reduce the fl ame, turn the knob further in
the same direction until its pointer is against
the
the same direction until its pointer is against
symbol (minimum fl ame position).
FOR HOB BURNERS EQUIPPED WITH
SAFETY DEVICE
- Press the knob and turn it anti-clockwise
until it reaches the
symbol on the control
panel (maximum fl ame position);
- move a burning match towards the burner,
keeping the knob pressed right down for
about 10 seconds;
- then release the knob and check that the
burner remains on. Otherwise, repeat the
operation.
SAFETY DEVICE
Burners equipped with this device have the
advantage that they are protected if they ac-
cidentally go out. If this occurs, the supply of
gas to the burner concerned is automatically
cut off, preventing the hazards deriving from
a leak of unburnt gas. The gas supply must
be cut off within no more than 90 seconds
for the hob burners.
AU For the user
Installation