Boneco H300 User Manual

32
en
ON MANUAL OPERATION
The BONECO H300 offers extensive possibilities for con-
trol and automation, which are controlled by the BONECO
app. Furthermore, some basic functions are available that
you can control manually using the knob on the front.
AUTO MODE
If you have never operated the BONECO H300 with the
BONECO app and switch it on for the first time, the appli-
ance will operate as a humidifier and air purifier in AUTO
mode. The appliance is preset to a target humidity of 50
percent. The performance level is automatically adapted
to the current humidity: The drier the air, the higher the
output level.
If the preset target humidity is exceeded by 2 percent, the
appliance switches to standby mode, which is indicated
by the pulsing LED:
If the humidity drops below the set level, the BONECO
H300 resumes operation.
ADAPTED AUTO MODE
If you have already operated the BONECO H300 with the
BONECO app and set a different humidity, that value is
automatically taken over when it is switched on.
SWITCHING ON AND OFF
1. Briefly press the output regulator once to switch on
the BONECO H300.
The appliance is always in AUTO mode when it is switched
on. You can identify active AUTO mode by the small LED
that lights up above the output regulator.
2. To switch off the BONECO H300 while it is in AUTO
mode, briefly press the output regulator once.
MANUAL OPERATION

Boneco H300 Specifications

General

Timer	Yes
Noise level	51 dB
Air purify rate	90 m³/h
Number of speeds	6
Water tank capacity	4.5 L
Suitable for room area up to	50 m²
AC input voltage	100 - 240 V
AC input frequency	50 / 60 Hz
Power consumption (max)	9.6 W
Power consumption (standby)	0.6 W
Placement	Floor
Product color	Black, White
Built-in display	No

Weight and Dimensions

Width	280 mm
Height	465 mm
Weight	5500 g