24
en
INSERTING A NEW UV LAMP
1. Remove the new UV lamp from the packaging.
2. Connect the clip of the new UV lamp to the cable
in the Therapure TP350. Make sure the clip notice-
ably engages.
3. Put the appliance back together by following the
steps in reverse order.
4. Connect the Therapure TP350 to the power out-
let.
5. Switch on the Therapure TP350.
6. Press and hold the button for the performance
control for about 5 seconds until the UV warning
signal on the display goes out.
REPLACEMENT FOR TPP6200 UV LAMP
You can obtain a new TPP6200 UV lamp from your
Therapure specialist dealer or the Therapure online
store at www.envion.com/en/tpp6200.
To Next Page
Loading...
