EasyManua.ls Logo

Bonex ECOS - User Manual

Bonex ECOS
39 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
BONEX-SCOOTER
Instruction for use
Version: 2016_08
INSTRUCTION FOR USE
BONEX-SCOOTER
ECOS
REFERENCE
DISCOVERY
REFERENCE RS
DISCOVERY RS

Table of Contents

Questions and Answers

  • M
    Michelle RogersAug 19, 2025
    Why my Bonex Diving vehicle scooter does not operate?
    • D
      David RiceAug 19, 2025
      There are several reasons why your Bonex diving vehicle scooter might not be operating: * The battery plug might not be connected, so connect it. * The battery might be empty, so recharge it. * The main switch might be off, so switch it on. * The fuse might be defective, so replace it. * The reed sensor might be defective, so replace it. * The main switch might be defective, so replace the main switch unit. * There might be a cable break, so replace the cable or switch unit. * The motor might be defective, so return it to the manufacturer. * The magnet of the drive switch might be missing, so glue a new magnet.
  • D
    Douglas WilliamsAug 21, 2025
    What to do if my Bonex Diving vehicle drive immediately stops after starting?
    • M
      Melissa MorganAug 21, 2025
      If your Bonex diving vehicle's drive immediately stops after starting, it could be due to: * Torque control: Switch the device off and then on again. * Temperature control: Switch the device off and then on again. * Low battery voltage: Recharge the battery.
  • V
    victoria25Aug 23, 2025
    Why does my Bonex Diving vehicle scooter have reduced power?
    • Q
      qperezAug 23, 2025
      Your Bonex diving vehicle scooter might have reduced power due to: * Low battery capacity: Replace the battery. * A defective propeller: Replace the propeller. * Corroded contacts: Return to the manufacturer. * A defective drive: Return to the manufacturer.
  • T
    Tracy CarsonAug 26, 2025
    What to do if charger diodes doesn't light on my Bonex Diving vehicle?
    • T
      Terry DixonAug 27, 2025
      If the charger diodes on your Bonex diving vehicle are not lighting, check the following: * Ensure there is current at the socket; try another socket. * Make sure the charging plug is properly connected; insert the plug. If these steps don't resolve the issue, the charger or battery might be defective, and you should return it to the manufacturer.
  • J
    Jennifer GreeneAug 28, 2025
    What to do if Bonex Diving vehicle scooter starts immediately after switching main switch on?
    • M
      Melissa KimAug 28, 2025
      If your Bonex diving vehicle scooter starts immediately after switching the main switch on, it could be due to: * The emergency drive switch being activated: Deactivate the emergency switch. * The drive switch (trigger) being pressed: Release the drive switch.
  • S
    Stacey Odonnell MDAug 30, 2025
    What causes inrush of water in Bonex ECOS Diving vehicles?
    • M
      Madeline HortonAug 30, 2025
      An inrush of water in Bonex diving vehicles can be caused by: * Leaking O-rings: Replace the O-ring. * A leaking sliding ring seal: Replace the sliding ring seal. If the housing is broken, return it to the manufacturer.
  • J
    Jeffery RodriguezSep 2, 2025
    What to do if the speed governor does not work on my Bonex Diving vehicle?
    • S
      steven99Sep 2, 2025
      If the speed governor on your Bonex diving vehicle does not work, it could be due to: * A defective speed governor: Replace the speed governor unit. * The emergency drive switch being activated: Deactivate the emergency switch.
  • A
    Amber PearsonSep 4, 2025
    Why emergency drive switch does not work on Bonex Diving vehicle?
    • J
      Jennifer ScottSep 4, 2025
      If the emergency drive switch on your Bonex diving vehicle does not work, it could be because: * The reed sensor is defective: Replace the reed sensor. * The magnet is removed from the round piece: Stick the magnet back in the round piece.
  • J
    Jonathan SteinSep 6, 2025
    What to do if the main switch does not turn off on my Bonex Diving vehicle?
    • M
      Michael PalmerSep 6, 2025
      If the main switch on your Bonex Diving vehicle does not turn off, it may be due to a temporary malfunction. Try turning the switch slowly a few times until you hear a click. If that doesn't work, disconnect all batteries and repeat turning the switch.
  • R
    Ronald JacksonSep 9, 2025
    How to fix sluggish housing or tube on Bonex Diving vehicle?
    • J
      juliaandersonSep 9, 2025
      If the housing or tube on your Bonex diving vehicle feels sluggish, it's likely due to soiled O-rings. Try these steps: * Clean the grooves. * Clean or change the O-rings. * Grease the housing with silicone.

Bonex ECOS Specifications

General IconGeneral
BrandBonex
ModelECOS
CategoryDiving vehicles
LanguageEnglish