Bonex ECOS - 14 Troubleshooting

BONEX-SCOOTER
Instruction for use
Version: 2016_08 Page 35
14. Troubleshooting
In case of malfunctions or failure, the table below presents a list of the most
typical problems.
Fault Cause of failure Remedy
Scooter does not
operate
>Battery plug not connected >Connect
>Battery empty >Recharge battery
>Main switch „OFF” >Switch main switch to „ON”
>Fuse defective >Replace fuse
>Reed sensor defective >Replace reed sensor
>Main switch defective >Replace main switch unit
>Cable break >Replace cable / switch unit
>Motor defective >Return to manufacturer
>Magnet of drive switch is missing >Glue a new magnet
Speed governor
does not work
>Speed governor defective >Replace speed governor unit
>Emergency drive switch activated >Deactivate emergency switch
Emergency drive
switch does not work
>Reed sensor defective >Replace reed sensor
>Magnet removed from round piece >Stick magnet in round piece
Scooter immediately
starts after switching
main switch „ON”
>Emergency drive switch activated >Deactivate emergency switch
>Drive switch (Trigger) pressed >Release drive switch
Drive immediately
stops again after
starting
>Torque control >Switch „OFF” and „ON”
>Temperature controlg >Switch „OFF” and „ON”
>Battery voltage too low >Recharge battery
Charger diode
s does
not light
>No current at socket >Choose other socket
>Charging plug not connected >Insert plug
>Charger defective >Return to manufacturer
>Battery defective >Return to manufacturer
Inrush of water
>O-rings leakage >Replace O-ring
>Sliding ring seal leakage >Replace sliding ring seal
>Broken housing >Return to manufacturer