BONEX-SCOOTER
Instruction for use
Version: 2016_08 Page 36
Fault Cause of failure Remedy
Switches sluggish >Dirt / sand on axle
>Rinse with water and
>oil axle afterwards
Housing, tube
sluggish
>O-rings soiled
>Clean grooves
>Clean / change O-rings
>Grease housing with silicone
Eccentric lever
sluggish
>Axle dry >Achse mit Silikon fetten
>Pressure disc worn >Replace pressure disc
Eccentric lever loose
>Pressure disc worn >Replace pressure disc
>Eccentric lever worn >Replace eccentric lever
>Pressure disc, Eccentric lever greasy >Clean and degrease
Main switch does
not turn off
>Temporarily malfunction of main
switch
> turn a few times slowly the
switch until you hear a click
sound
> Disconnect all batteries and
repeat turning the switch
Scooter has reduced
power
>Battery capacity too low >Replace battery
>Propeller defective >Replace propeller
>Contacts corroded >Return to manufacturer
>Drive defectivet >Return to manufacturer
To Next Page
Loading...