2
BONMET motion GmbH/www.bonmet.com/www.bonmet.de
Safety Precautions
● To prevent electric shock, note the following:
· Before wiring or inspection, switch power off and wait for more than 10 minutes. Then,
confirm the voltage is safe with voltage tester. Otherwise, you may get an electric shock.
· Wiring must be carried by electrical engineer.
· Connect the servo drive and servo motor to ground.
· Operate the switches with dry hand to prevent an electric shock.
· The cables should not be damaged, stressed, loaded, or pinched. Otherwise, you may get an
electric shock.
● To prevent fire, note the following:
· Do not install the servo drive, servo motor and regenerative brake resistor on or near
combustibles. Otherwise a fire may cause.
· When the servo drive has become faulty, switch off the main power. Continuous flow of a
large current may cause a fire.
· When there is a signal faulty as a regenerative brake resistor is used, please switch the main
power off. Otherwise, a regenerative brake transistor fault may overheat the regenerative
brake resistor and cause a fire.
· Wire the equipment correctly and securely.
· Connect the output terminals (U, V, W) correctly.
· Do not connect AC power directly to the servo motor or servo drive.
● Operation and Adjustment Precautions
· Do not touch the radiator and the regenerative brake resistor as they are overheated.
· Do not set parameter value unduly. If so, system would be instable.
· Do not touch the rotating parts of the servo motor in operation. Doing so may cause injury.
· Do not attempt to remold the servo drive.
To Next Page