Removal of leover paper:
Turning off:
Separate cung unit for CDs and credit cards:
Inser t credit card:
Insert CDs:
Technical specificaons:
Set the switch to “OFF” and unplug the power socket. Remove the shredding aachment and then you will
able to take out any scraps of paper that have become caught in the cung unit. The blades are very sharp
so you should proceed with extra cauon! Place the shredder aachment back on top, plug in the power
socket and turn the device on again. You will then be able to start using the device again.
Set the switch to “OFF” in order to turn the device off enrely.
This shredder is fied with a separate cung unit for CDs/DVDs and credit cards. Set the switch to FWD
and insert the CDs / DVDs into the slot behind the flap where they will be cut into 3 pieces. Keep your
face at a suitable distance from the device when inserng CDs/DVDs since these materials are at risk of
spling. The shredded material is collected in a separate container which will help you dispose of the
waste in an environmentally-friendly manner.
1. Open the security door on the CD / credit card input opening.
2. Insert the card into the top center of the CD / credit card input opening. You can only cut up one credit
card at the me. Do this always ahead with the broad side into the CD / credit card input opening.
Otherwise, the magnec strip is not destroyed.
1. Insert the CD centrally from above into the CD / credit card input opening. You can only cut just one CD.
2. Do not insert your finger into the central hole of the disc when you insert it into the device, there is
danger of injury!
Cung acon: Strip-Cut
Cut size: 15\65”×1063\64” (paper), 3 pieces (CD/DVD or credit card)
Cung capability: 8 pages DIN A4 (75g), 1 CD/DVD or credit card
Input slot width: 8.7 inches for paper
Input slot width for CDs/DVDs: 4.7 inches
Input voltage: 120 VAC,60 Hz, 1.5 A
Paper basket: 3.4 gallons
Safety level DIN 66399-2: P-1
5
To Next Page
Loading...
Need help?
General
