Bonsaii S120-C User Manual

Shredder capacity:
How to operate:
Shredding paper
Overloading:
Overheang:
The S120-C is capable of shredding up to 8 sheets of paper (DIN A4, 75g/m²) at once. Paper width may not
exceed 22cm. When shredding small pieces of paper, such as envelopes or credit card receipts, the paper
should be inserted in the middle of the opening. Please ensure that you never insert more than the stated
maximum quanty into the cung unit as this may damage the device.
Set the switch on the front side to “AUTO”. The device will then be ready to operate.
Insert a maximum of 8 sheets of paper (75g/m²) in portrait orientaon into the input slot. The paper will
be recognised by the sensors, the cung unit will start and the paper will be automacally drawn in. The
operaon will finish once there is no more paper in the cung unit.
If you insert too much paper, the cung unit will stop. In this event, set the switch to “REV” in order to
remove the paper. Reduce the number of sheets and then try again.
If you exceed the indicated maximum operang me of 3 minutes, there is a possibility of the motor
overheang. In this event, the cung unit will stop. The drive will be automacally disconnected from
the power and will restart on its own once the motor has cooled down sufficiently. You should therefore
set the switch to the “OFF” posion and let the device cool down for an appropriate length of me. The
maximum connuous operaon me of 3 minutes can only be reached with a sufficiently cool device.
Cooling the device down sufficiently to operate it again for 3 minutes takes around 30 minutes.
4

Bonsaii S120-C Specifications

General

Brand	Bonsaii
Model	S120-C
Category	Paper Shredder
Language	English