4
BEFORE USING YOUR ELECTRIC KETTLE
USING YOUR ELECTRIC KETTLE
If you are using the kettle for the first time, it is recommended that you clean
your kettle before use by boiling a full kettle of water twice and then discarding
the water.
1.To fill water into the kettle, remove it from the power base and open the lid by
lifting it, fill with the desired amount of water to the kettle. Always fill the kettle
between the minimum 0.5L and maximum 1.7L marks for water boiling,
and fill the kettle between the minimum 0.5L and maximum 1.2Lmarks for
tea brewing.
Too little water will result in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water
may spill out of the spout when boiling. Ensure that the lid is firmly
in place before connecting the power cord to the outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. The display turns on for a moment, all
buttons and indicator lights are lit and the appliance beeps once which means
that the base is connected to the power source and the kettle is placed on the
base.
4. Close the lid and place the kettle on the power base , the appliance beeps
once, the display turns on and starts to flash. On the display you will see the
current water temperature which will be visible for about 10 seconds. If you do
not perform any actions, the kettle turns off automatically and all lights go out.
5.Press the ON/OFF button without setting other functions. The kettle turns on
and beeps, the display starts to flash. the kettle boils water up to 100°C, then
switches off automatically when reach 100°C with a long beep.
To Next Page
Loading...
