BOIL-DRY PROTECTION
CLEANING AND MAINTENANCE
REMOVEL OF MINERAL DEPOSITS
Should you accidentally allow the kettle to operate without water, the boil-dry
protection will automatically switch it off. If this should occur, allow the kettle to
cool before filling with cold water and re-boiling.
Always disconnect the appliance from the power outlet before cleaning. Never
immerse the kettle or cord in water, or allow moisture to contact with these parts.
Mineral deposits in tap water may cause the kettle interior to discolor .To remove
this build-up, use Liquid Descaler, a simple to use non-toxic cleaner.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar and the remainder with water and
be allowed to stand overnight. Do not boil.
2. Empty the solution from the kettle. Any stains remaining inside the spout can
be removed by rubbing with a damp cloth, fill the kettle with clean water, bring
to boil and then discard the water. Repeat and the kettle will then be ready to
use. The outside of the kettle can be wiped over with a damp cloth.
6
Cleaning appearance of housing
Wipe the appearance of housing with a wild and damp cloth or cleaner, never
use a poisonous cleaner.
Cleaning the filter
Remember to clean the filter with a wild and damp cloth at intervals. The filter
can be detached for easier cleaning simply by pulling it out.
CAUTION: Do not use chemical, steel, wooden or abrasive
cleaners to clean the outside of the kettle.
To Next Page
Loading...