BONTEC GWM01 - Important Safety Information; Tools Needed (Not Included); Supplied Parts and Hardware; Parts for Step 1

IMPORTANT SAFETY INFORMATION
e Please carefully read all instructions before attempting installation.
CAUTION: Avoid potential personal injuries and property damage!
e This product is designed for use in wood stud, solid concrete, concrete block
and
brick walls. — DO NOT install into drywall alone.
e Do not use this product for any purpose that is not explicitly specified in this
manual. Do not exceed weight capacity. We are not liable for damage or injury
caused by improper mounting, incorrect assembly or inappropriate use.
‘» This product contains a high pressure gas spring, fire and percussion prohibit-
ed. Also it is strictly prohibited to dismantle without professionals. Please return
to the manufacturer or hand over to professional agencies if the product is
abandoned.
e The wall must be capable of supporting three times the weight of the total load
(the mount, the monitor and all accessories weight).
Check the VESA Pattern of Your Monitor before the Installation
/
75 mm = 3in
100 mm = 4 in
200 mm = 7 7/8 in
Minimum VESA pattern: 75mm/3 in.(W)x75mm/3 in.(H)
[ if your Monitor VESA is greater than 200x200 mm/6x8 in. or less than 1
VESA 75x75mm/3x3in., this mount is NOT compatible.
01
Verify Your Wall Construction ‘
®/
§L
If
t
th
A\
CAUTION
:
you
are
not
sure
the
;
wall
construction,
'DO
NQT
please
contact
our
install
into
customer
service
at
drywall
alone
Wood
Studs
Solid
Concrete
supporteu@ergear.com.
(with
Drywall)
or
Concrete
Block
Tools
Needed
(Not
Included)
'
’
g / 7 &
Tape Measure
Stud
Finder
Pencil
Drill
Awl
/
/
%
/
ee
D)
el
5/32in.(4mm)
3/8
in.(10mm)
3/8in.(10mm)
Phillips
Lovel
Wood
Drill
Concrete
Drill
Socket
Wrench
Screwdriver
Supplied Parts and Hardware
AWarning:
This
product
contains
small
items
that
could
be
a
choking
hazard
if
swallowed.
*
Before
starting
assembly,
verify
all
parts
are
included
and
undamaged.
Do
not
use
damaged
or
defective
parts.
If
you
require
replacement
parts,
contact
our
customer
service
at
supporteu@ergear.com.
*
Please
note:
Not
all
hardware
included
in
this
package
will
be
used.
Supplied Parts and Hardware for Step 1
Faceplate
Extender
Bracket
M5
Nut
M5x12
Bolt
[02]
X1
[03]
x2
[04]
x
2
M-G
x8
M-H
x8
02