Bosch 0 601 7D1 600 - Restart protection; Soft start; Constant Electronic control; Kickback control

English | 31
Restart protection
The restart protection feature prevents the power tool from
uncontrolled starting after the power supply to it has been
interrupted.
To restart the tool, set the on/off switch(3) /(6) to the "off"
position and then switch the power tool on again.
Soft start
The electronic soft start limits the torque when the power
tool is switched on and enables a smooth start-up.
Note: If the power tool runs at full speed immediately after
being switched on, this means that the soft start and restart
protection mechanisms have failed. The power tool must be
sent to the after-sales service immediately; see the "After-
Sales Service and Application Service" section for ad-
dresses.
Constant Electronic control
The Constant Electronic keeps the speed at no load and un-
der load virtually consistent, guaranteeing uniform perform-
ance.
Kickback control
If there is a sudden kickback in the power tool,
e.g. jamming in a separating cut, the power
supply to the motor will be interrupted elec-
tronically.
To restart the tool, set the on/off
switch(3) /(6) to the "off" position and then switch the
power tool on again.
Drop control
(GWS 17-125 SB / GWS 17-125 PSB)
DROP
CONTROL
The integrated impact shutdown switches the
power tool off as soon as it hits the floor. To re-
start the tool, set the on/off switch(3) /(6) to
the "off" position and then switch the power
tool on again.
Run-out brake
(GWS 17-125 SB / GWS 17-125 PSB)
INTELLIGENT
BR AKE S YST EM
The power tool is fitted with an electronic run-
out brake. When the power tool is switched off
or the power supply is interrupted, the abras-
ive tool is brought to a complete stop within a
few seconds.
Speed preselection
(GWS 14-125 S / GWS 17-125 S / GWS 17-125 TS / GWS17-125SINOX / GWS17-150S / GWS17-125SB /
GWS17-125PS / GWS17-150PS / GWS17-125PSB)
You can preselect the required speed using the speed preselection thumbwheel(5), even during operation, provided the dust
filter(4) is not fitted. Otherwise remove the dust filter(4) beforehand. The information in the table below describes the re-
commended values.
Material Application Application tool Thumbwheel position
Metal Removing paint Sanding sheet 2–3
Metal Brushing, removing rust Cup brush, abrasive disc 3
Stainless steel Grinding Grinding disc/fibre disc 4–6
Metal Rough grinding Grinding disc 6
Metal Cutting Cutting disc 6
Stone Cutting Diamond cutting disc 6
u The rated speed of the accessory must be at least
equal to the maximum speed marked on the power
tool. Accessories running faster than their rated speed
can break and fly apart.
Level
Speed preselec-
tion
GWS 14-125 S
GWS 17-125 S
GWS 17-125 SB
GWS 17-125 PS
GWS 17-125 PSB
[min
-1
]
GWS 17-125 S INOX
[min
-1
]
GWS 17-125 TS
GWS 17-150 S
GWS 17-150 PS
[min
-1
]
1 2800 1900 2400
2 4500 3300 4100
3 6300 4400 5400
4 8200 5400 6700
5 9800 6500 8000
Bosch Power Tools 1 609 92A 99S | (24.01.2024)