Installation Option #1: Hardwire
Hardwire Electrical
supply conductors shall be
a minimum #14 AWG
copper wire
rated at 167°F or higher
Connect wires to junction box
terminal block and securely
tighten
the terminal block screws
Plug the end of the power cord
into the back of the dishwasher as
shown
until it clicks
Home Appliances - For Internal Use Only - Do Not Distribute
Internal use only| PDC-RNA/MK | March 2013| © Robert Bosch Hausgeräte GmbH, Munich reserves all rights even in the event of industrial
property rights. We reserve all rights of disposal such as copying and passing on to third parties..
4
The dishwasher is designed for an electrical supply of 120V, 60 Hz, AC, connected to a dishwasher-dedicated,
properly grounded electrical circuit with a fuse or breaker rated for 15 amps.
To Next Page
Loading...
