Why is my Bosch Ranges oven not heating?
If your Bosch Ranges oven isn't heating, check the circuit breaker or fuse box to ensure the oven is receiving proper electrical power. Also, verify that you have selected an oven temperature.
What to do if my Bosch Ranges oven door is locked?
If your Bosch Ranges oven door is locked and won't open, even after cooling, turn the oven off at the circuit breaker and wait five minutes. Then, turn the breaker back on. This should reset the oven and make it operable again.
What does it mean when my Bosch Ranges oven control panel beeps and displays an F code error?
If your Bosch Ranges oven control panel beeps and displays an F code error (like F10, F11, F13, F14, F15, F30, F31, or F90), it means the oven control has detected a fault or error. Press CANCEL to clear the display and stop the beeping. Then, try the bake or broil feature again.
Why is my Bosch Ranges entire appliance not operating?
If your entire Bosch Ranges appliance isn't operating: * Ensure the time of day is set, as the oven won't operate until this is done. * Check if there was an electrical power outage. If these steps don't resolve the issue, further assistance is needed.
How to fix a Bosch Ranges appliance that is not level?
If your Bosch Ranges appliance is not level, it may be due to poor installation. Ensure the floor is level, strong, and stable enough to support the range. Place an oven rack in the center of the oven, put a level on the rack, and adjust the leveling legs at the base of the appliance until the rack is level. Also, confirm that the cabinets are square and have sufficient room for appliance clearance.
Why is my Bosch Ranges oven light not working properly?
If the oven light in your Bosch Ranges is not working properly, replace or reinsert the light bulb if it is loose or defective.
Why is my Bosch Ranges clock and timer not working properly?
If the clock and timer on your Bosch Ranges are not working properly, make sure there is electrical power to the oven.
How to fix Bosch Ranges surface burners that do not ignite?
If the surface burners on your Bosch Ranges do not ignite: * Ensure the surface control knob is completely turned to LITE. Push in and turn the surface control knob to LITE until the burner ignites, then turn the knob to the desired flame size. * Check for clogged burner ports. With the burner OFF, use a small-gauge wire or needle to clean the burner head slots and ignition ports. * For electric ignition models, make sure the range power cord is securely plugged into the power outlet. * In case of an electrical power outage (electric ignition models only), burners can be lit manually.
Why is my Bosch Ranges oven smoking excessively during broiling?
If your Bosch Ranges oven smokes excessively during broiling, ensure you are following the broiling instructions in the Setting Oven Controls section.
What to do if my Bosch Ranges oven is not self-cleaning properly?
If your Bosch Ranges oven is not self-cleaning properly, allow the oven to cool before running the self-clean cycle. Also, always wipe out loose soils or heavy spillovers before starting the self-clean function.
General| Capacity | 16 place settings |
|---|---|
| Noise Level | 44 dBA |
| Number of Wash Cycles | 5 |
| Tub Material | Stainless Steel |
| Rack Material | Nylon |
| Manufacturer | Bosch |
| Series | 300 Series |
| Type | Built-In |
| Number of Options | 4 |
| RackMatic | Yes |
| Leak Protection System | AquaStop |
| Energy Star Qualified | Yes |
| Water Consumption | 2.9 gallons per cycle |
| Drying System | PureDry |
| Third Rack | Yes |
| Soil Sensor | Yes |
| Energy Consumption | 269 kWh/year |
| Water Filtration System | Three stage |
| Cycle Options | Auto, Heavy, Normal, Speed60, Rinse |
| Delay Start | Yes |
| Dimensions | 23.5625 x 33.875 x 23.75 inches |
To Next Page