Bosch 300 Series - Detergent Table; Dishware; Damage to Glassware and Dishware

21
WARNING
CAUTION
Avoid Scald Hazard
Do not perform any work on a charged hot water line. Serious injury
FRXOGUHVXOW2QO\TXDOL¿HGSOXPEHUVVKRXOGSHUIRUPSOXPELQJZRUN
Do not attempt any work on the dishwasher hot water supply plumb-
ing until you are certain the hot water supply is shut off.
Temperatures required for soldering and sweating will damage the
dishwasher. If plumbing lines are to be soldered or sweated, keep the
heat source at least 6 inches (152.4 mm) away from the dishwasher.
Hot Water Supply
7KHKRWZDWHUKHDWHUVKRXOGEHVHWWRGHOLYHUDSSUR[LPDWHO\)&
water to the dishwasher. Water that is too hot can cause some detergents
to lose effectiveness. Lower water temperatures will increase run times.
7KHKRWZDWHUVXSSO\SUHVVXUHPXVWEHEHWZHHQSVLEDU
IMPORTANT NOTES:
 ,IXVLQJDVROGHUMRLQWLQVWHDGRIDFRPSUHVVLRQ¿WWLQJEHVXUHWRPDNH
all solder connections before connecting the water supply line to the
dishwasher.
 0DNHVXUHWKHUHDUHQRVKDUSEHQGVRUNLQNVLQWKHZDWHUOLQHWKDWPLJKW
UHVWULFWZDWHUÀRZ
 Always use the appropriate seal when making plumbing connections.
 %HIRUHFRQQHFWLQJWKHZDWHUVXSSO\OLQHWRWKHGLVKZDVKHUÀXVKWKH
LQFRPLQJZDWHUOLQHIRUDSSUR[LPDWHO\PLQXWHVWRFOHDUDQ\IRUHLJQ
material.
 Turn on the water supply and check for leaks after connections are
made.
Water Inlet Connections