VG4 Modular Camera Series Installing the In-Ceiling Mount | en 87
Bosch Security Systems, Inc. Installation Manual F.01U.216.010 | 8.0 | 2011.02
Figure 4.13 In-Ceiling Bubble
Bubble Removal
To service the In-Ceiling AutoDome, use the following procedure to remove the Bubble:
1. Loosen the lockscrew (item 1 in the illustration below) in the trim ring using a P1 or
smaller Phillips screwdriver until the bubble can rotate freely.
2. Then rotate the bubble counterclockwise approximately 1/4 turn until it releases from
the In-Ceiling Housing. See the figure below for an illustration.
Figure 4.14 Bubble Release Screw
1 In-ceiling Housing 3 Camera Module
2 Ceiling 4 Bubble
To Next Page
Loading...
