37.
Accessories
DWM40L MiterFinder™ Digital Angle
finder/Compound Cut Calculator/Protractor/Level
– Gives you the information needed to position cuts
s
o that they fit together precisely even if the room is
out of square.
M
S1220 Folding Stand with Wheels
–
Provides
solid support for saw and easy transport into & out of
job sites.
MS1221 Horizontal Quick Clamp Crown Stop
Bracket
– Clamps workpiece against fence. Can
also be used as a crown molding stop. Mounts to left
or right side of the table.
MS1222 Extra-Long Base Rod Kit – Consists of
replacement steel rods that extend the total width of
base to 5 ft. (60").
M
S1223 Length Stop Kit.
MS1224 Replacement Kerf Inserts
MS1225 Replacement Dust Bag
MS1226 Replacement (Vertical) Quick Clamp
T3B TracRac™ Portable Stand with Wheels
Increases material capacity to 20 feet.
To Next Page
Loading...
