What causes a refrigerant cylinder to be full in a Bosch Other?
A refrigerant cylinder can be full in a Bosch Other because the weight limit has been reached, so you should reduce the quantity of refrigerant in the internal refrigerant cylinder. Another reason might be that the scale is defective, in that case replace the scale.
What to do if Bosch ACS 651 Service Equipment R134a recharge shows high pressure in vehicle?
If there's high pressure in the vehicle during an R134a recharge with your Bosch Service Equipment, perform recovery.
What to do if Bosch Service Equipment detects leak during vacuuming?
If a leak is detected during vacuuming with the Bosch Service Equipment, check if the used oil bottle is disconnected. If it is, connect the bottle.
What to do if Bosch ACS 651 Service Equipment oil recharge shows high pressure in vehicle?
If the Bosch Service Equipment indicates high pressure in the vehicle during an oil recharge, perform recovery.
What to do if Bosch ACS 651 UV dye recharge shows high pressure in vehicle?
If the Bosch Service Equipment indicates high pressure in the vehicle during a UV dye recharge, perform recovery.
What does 1002 RECOVERY mean on Bosch ACS 651 Service Equipment?
If the Bosch Service Equipment displays a 1002 RECOVERY error, this indicates a high pressure shutdown. Check for any blockages in the vehicle A/C system.
What to do if the fresh oil bottle is not found in my Bosch Other?
If the fresh oil bottle is not found, check if the fresh oil bottle is disconnected; if it is, connect the bottle. Also, check the oil bottle scale and check for blockage on the oil charge solenoid path.
What to do if my Bosch Other experiences a high pressure shutdown?
If your Bosch Other experiences a high pressure shutdown, allow the unit to cool for 30 minutes and then switch it on again. Also, try recovery/hose drain and check if the blue knob on the internal refrigerant tank is closed; if it is, open it. Check the electrical connections to the pressure switch to ensure they are connected. Verify there is no blockage in the discharge tube, manifold, or blue hose between the tank and valve block, and rectify any leakage. In debug mode, switch on CX and check if the compressor is functioning.
What to do if there is insufficient R134a quantity in my Bosch Other?
If there is insufficient R134a quantity, fill the internal refrigerant cylinder.
What to do if Bosch Service Equipment UV dye recharge says insufficient UV dye quantity?
If the Bosch Service Equipment indicates an insufficient UV dye quantity during a UV dye recharge, fill the UV dye bottle.
General| Refrigerant | R134a |
|---|---|
| Compressor Type | Hermetic |
| Power Supply | 230V, 50/60Hz |
| Display | LCD |
| Input Voltage | 230V |
| Recovery Rate | 0.3 kg/min |
| Operating Modes | Automatic, Manual |
To Next Page
