Bosch AKE 30 LI User Manual (English)

Questions and Answers:

T
Tyler WarrenAug 6, 2025
What to do if my Bosch AKE 30 LI chain/guide bar is hot?
- J
  Juan LewisAug 6, 2025
  If your Bosch chainsaw's chain or guide bar is hot, it could be due to several reasons. First, check if there is oil in the reservoir and refill if needed. A clogged oil passage can also cause this issue, so clean the oil passage. Additionally, the chain tension might be too high (tension the saw chain), or the saw chain could be dull (sharpen or replace the saw chain).
E
emartinezAug 10, 2025
What to do if my Bosch AKE 30 LI rips, vibrates, does not saw properly?
- C
  Christopher Coleman IIIAug 10, 2025
  If your Bosch chainsaw is ripping, vibrating, or not sawing properly, the chain tension might be too loose; in this case, tension the saw chain. Also, the saw chain could be dull or worn out, so sharpen or replace it as needed. Finally, ensure the chain teeth are facing in the correct direction and reassemble if necessary.
Z
Zachary McdanielAug 15, 2025
Why is my Bosch Chainsaw chain running slow?
- L
  Laurie MartinAug 15, 2025
  If the saw chain on your Bosch chainsaw is running slow, it could be due to a discharged battery (recharge the battery). Another potential cause is that the battery was stored outside of its recommended temperature range. Allow the battery to warm naturally to room temperature (within the battery operating temperature 0 – 45 °C).
C
Courtney AndersenAug 19, 2025
Why is my Bosch AKE 30 LI vibrating excessively?
- J
  Joseph CollinsAug 19, 2025
  Excessive vibrations or noise in your Bosch chainsaw can be caused by several factors. It could be due to too much friction from a lack of lubricant, so ensure that lubrication is working. The saw chain may need cleaning, or your sawing technique might be poor. Also, a battery not fully charged can cause this issue, so recharge the battery.