Bosch B3512 - Page 109

Network Address
Port Number
Poll Rate (seconds)
Format
AES Size
AES Entry
B91x/B92x keypads configuration of Enhanced Comm Parameters
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [1] Reporting > [2] Network > [2] Enhanced Comm Parms. The
keypad scrolls the entries for the selected Enhanced Comm destination.
3. Use [PREV] or [NEXT] to go to the destination you want to edit.
4. Press [ENTER] to edit the selected Enhanced Comm destination. The keypad asks if you
want to edit the address.
5. Press [ENTER] to edit the network address. The existing address and an editing cursor
show.
6. Delete existing characters, if necessary, and then enter the new address.
7. Press [ENTER] to save the address. The keypad shows Parameter Saved.
8. Press [NEXT]. The currently configured port number shows, and the keypad asks if you
want to edit it.
9. Press [ENTER] to edit the port number. The existing port number and an editing cursor
show.
10. Delete existing characters, if necessary, and then enter the new rate.
11. Press [ENTER] to save the port. The keypad shows Parameter Saved.
12. Press [NEXT]. The currently configured poll rate shows, and the keypad asks if you want
to edit it.
13. Press [ENTER] to edit the poll rate. The existing poll rate and an editing cursor show.
14. Delete existing characters, if necessary, and then enter the new poll rate.
15. Press [ENTER] to save the poll rate. The keypad shows Parameter Saved.
16. Press [NEXT]. The current format (Modem4 or Contact ID) shows.
17. Press [ENTER] to edit the format.
18. Use [PREV] or [NEXT] to select the desired format, Modem4 or Contact ID.
19. Press [ENTER] to save the format. The keypad shows Parameter Saved.
20. Press [NEXT]. The current AES key size shows.
21. Press [ENTER] to edit the AES key size.
22. Use [PREV] or [NEXT] to select the desired size.
23. Press [ENTER] to save the size. The keypad shows Parameter Saved.
24. .Press [ESC] to return to the list of enhanced comm options, or press and hold [ESC] to
exit the Installer menu.
B93x/B94x keypads configuration of Network Address, Poll Rate (seconds), and Port
Number
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [1] Program > [1] Reporting > [2] Network > [2] Enhanced Comm Parms. The
keypad shows the network address for the selected Enhanced Comm destination.
Control Panel
Keypad Installer menu | en 109
Bosch Security Systems, Inc. Installation and System Reference Guide 2015.07 | 12 | F.01U.287.180