Bosch B6512 - Page 146

147 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Table of Contents

Default Chapter3
- Table of Contents3
Certifications, Approvals, Listings, and Safety8
- Listings and Approvals8
- Ulc8
- Security Industry Association (SIA)8
- Department of Defense (Dod)8
- Department of Energy8
- California State Fire Marshal (CSFM)8
- National Institute of Standards and Technology (NIST)8
- Federal Communications Commission (FCC) Rules9
- Industry Canada (IC)9
- Safety10
- Lightning10
- Power10
Introduction12
- About Documentation12
- Related Documentation12
- Bosch Security Systems, Inc. Product Manufacturing Dates13
System Overview15
- Parts List15
- Control Panel Capacities15
Installation Checklist16
Control Panel Installation17
- Installing the Enclosure and Wiring Label17
- Installing the Control Panel17
- Earth Ground19
- OUTPUT a Jumper19
- Control Panel to Module Wiring Overview19
Power Supply21
- Primary (AC) Power21
- Secondary (DC) Power21
- Install the Battery21
- Battery Maintenance23
- Battery Supervision23
- Battery Discharge and Recharge Schedule23
- B520 Aux Power Supply23
- SDI2 Address Settings24
- Supervision24
- Auxiliary Power Supply Trouble Conditions24
- Installation and Control Panel Wiring (B520)24
- Powered Device and Battery Wiring26
Telephone Communications28
- B430 Plug-In Communicator, Telephone28
- Supervision28
- Installation and Module Wiring (B430)28
- Diagnostic Leds29
- Phone Jack Location29
- Telephone Line Monitor30
- Called Party Disconnect30
- Communication Failure31
IP Communications32
- On-Board Ethernet Connection32
- Supervision32
- Local Programming32
- On-Board Ethernet Diagnostic Leds33
- Conettix Plug-In Cellular Modules34
- B426 Ethernet Communication Module34
- Address and Emulation Settings34
- Supervision34
- B426 Module Faults34
- Installation and Control Panel Wiring (B426)35
- Diagnostic Leds36
- Local Programming38
- B450 Conettix Plug-In Communicator Interface38
- SDI2 Address Settings38
- Supervision38
- Installation and Control Panel Wiring (B450)38
- Diagnostic Leds39
- Compatible Receivers for IP Communication40
Keypads, Keyswitches, Keyfobs and Transmitters42
- Keypads42
- Keypads Overview42
- B921C Two-Line Capacitive Keypad with Inputs43
- Shortcuts and Custom Functions43
- Address Settings44
- Supervision44
- Installation and Control Panel Wiring (Keypads)44
- Sensor Loops Overview and Wiring (B921C/B942/B942W Only)45
- Output Wiring (B942/B942W Only)46
- Troubleshooting46
- Keyswitches46
- Operation46
- Installation and Control Panel Wiring (Keyswitches)46
- RADION Keyfobs and Inovonics Pendant Transmitters47
On-Board Outputs49
- Circuit Protection49
- Total Available Power49
- Open Collector Outputs50
Off-Board Outputs51
- B308 Octo-Output Module51
- SDI2 Address Settings51
- Supervision51
- Installation and Control Panel Wiring (B308)52
On-Board Points54
- Point Sensor Loops54
- Single EOL (and no EOL) Resistor Circuit Style54
- Dual EOL Resistor Circuit Style55
- Point Response Time56
Off-Board Points57
- B208 Octo-Input Module57
- SDI2 Address Settings57
- Supervision57
- Installation and Control Panel Wiring (B208)57
- Sensor Loops Overview and Wiring59
- Off-Board Points Test61
- Extra Point Events61
- Missing Point Conditions61
Wireless Modules62
- B810 Receiver62
- SDI2 Address Settings62
- Supervision62
- Installation and Control Panel Wiring (B810)62
- B820 SDI2 Inovonics Interface Module63
- SDI2 Address Settings63
- Supervision63
- Installation and Control Panel Wiring (B820)63
Access Control65
- B901 Door Controller65
- Address Settings65
- Supervision65
- Installation and Control Panel Wiring (B901)65
- Card Reader Wiring66
Program and Test the Control Panel67
- Program the Control Panel67
- Program the Control Panel with RPS67
- Program the Control Panel with the Installer Services Portal Programming Tool68
- Program the Control Panel with a Keypad68
- Walk Tests68
- Fire Walk Test68
- Intrusion Walk Test69
- Service Walk Test69
- Invisible Walk Test70
Control Panel Board Overview71
System Wiring Diagrams73
- System Wiring Overview73
- Battery Lead Supervision Wiring74
- 2-Wire Smoke Wiring (B201)75
- 2-Wire Smoke Wiring (D125B)76
- Notification Appliance Circuit Wiring76
- SDI2 Devices General System Wiring78
- SDI2 Bus Wiring Recommendations78
- Wiring Label81
Approved Applications82
- Optional Compatible Equipment82
- Burglar Applications82
- Bank Safe and Vault Applications82
- Fire Applications85
- Enclosures86
- Combination Fire and Intrusion Alarm Systems87
- Compatible UL Listed Components87
- Standby Battery Requirements and Calculations89
- Household Fire Warning Equipment91
- UL 365 - Police Station Connected Burglar Alarm Units and Systems92
- UL 636 - Holdup Alarm Units and System92
- Required Values to Achieve 180S (Ulc)/200S (UL) Supervision Interval92
- Ulc93
Keypad Installer Menu94
- Program Menu (Programming)101
- Reporting > [1] Phone Menu Parameters101
- Reporting > [2] Network Menu Parameters102
- Reporting > [3] Routing Menu Parameters103
- Reporting > [4] Personal Note Menu Parameters104
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [1] Module105
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [2] Address106
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [3] DNS107
- Network > [2] Cellular > (Choose the SDI2 Cellular Module or Plug-In Module)108
- RPS > [1] RPS Passcode Menu Parameters109
- RPS > [2] RPS Phone Number Menu Parameters109
- RPS > [3] RPS IP Address Menu Parameters109
- RPS > [4] RPS Port Number Menu Parameters110
- Area Options Menu Parameters110
- Keypad Menu Parameters111
- Users Menu Parameters112
- Points Menu Parameters113
- Disable Programming Menu120
- Wireless Menu120
- RF Point Menu> [1] Enroll Point RFID120
- RF Point Menu> [2] Replace Point RFID120
- RF Point Menu> [3] Remove Point RFID121
- RF Repeater Menu > [1] Add Repeater121
- RF Repeater Menu > [2] Replace Repeater121
- RF Repeater Menu > [3] Remove Repeater122
- RF Diagnostic Menu > [1] RF Points122
- RF Diagnostic Menu > [2] RF Repeater Menu122
- Diags Menu123
- Wireless123
- Network Menu123
- Cellular Menu123
- IP Camera124
- Cloud124
- Service Bypass (Serv Byp) Menu124
- Versions Menu125
- Cloud Menu126
Specifications127
- Wire Requirements129
Appendix130
- Address Settings130
- B208 Address Settings130
- B308 Address Settings130
- B901 Address Settings131
- B91X Address Settings131
- Reporting and Device Number Information132
- Report Format Definitions132
- SDI2 Address Information141
- Device Numbers (Zzz, DDDD)142
- Communication Trouble Device Numbers (Zzzz)142
- Special User Ids (Uuuu, IIII)143
- Keypad Alarm Virtual Point Numbers (Ppp, Pppp)143
- Autoip144

Other manuals for Bosch B6512

Quick User Guide56 pages

Related product manuals

Preview: Bosch B5512

Preview: Bosch B9512G

Preview: Bosch B8512G

Preview: Bosch B9512G-E

Preview: Bosch MPC-xxxx-B

Bosch MPC-xxxx-B

Preview: Bosch FPD-7024

Preview: Bosch FPA-5000

Preview: Bosch 2000 Series

Bosch 2000 Series