Bosch B9512G-E - Page 2

185 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Table of Contents

Default Chapter3
- Table of Contents3
Certifications, Approvals, Listings, and Safety9
- Listings and Approvals9
- Ulc9
- Security Industry Association (SIA)9
- Department of Defense (Dod)9
- Department of Energy9
- National Institute of Standards and Technology (NIST)9
- Federal Communications Commission (FCC) Rules10
- Industry Canada (IC)10
- Safety11
- Lightning11
- Earth Ground11
- Power12
Introduction13
- About Documentation13
- Related Documentation13
- Bosch Security Systems, Inc. Product Manufacturing Dates15
System Overview16
- Parts List16
- Control Panel Capacities16
- Features17
- SDI2 Interconnect Wiring17
- Points17
- Areas and Accounts17
- Digital Communication18
- Keypads18
- Events18
- Programming19
- Firmware Updates19
- Access Control19
- Ground Fault Detection19
- Dual Authentication19
- Recent Closing20
- Accessories20
- Compatible UL Listed Synchronization (Sync) Modules and Strobes25
Installation Checklist30
Control Panel Installation31
- Installing the Enclosure31
- Installing the Control Panel31
- Earth Ground32
- Ground Fault Detect Enable32
- Ground Fault Detection Troubleshooting32
- Control Panel to Module Wiring Overview33
Power Supply36
- Secondary (DC) Power36
- Install the Battery36
- Battery Status Led37
- Battery Maintenance38
- Battery Supervision38
- Battery Charging Circuit Float Charge38
- Battery Discharge and Recharge Schedule39
- B520 Aux Power Supply39
- SDI2 Address Settings40
- Supervision40
- Auxiliary Power Supply Trouble Conditions40
- Installation and Control Panel Wiring (B520)40
- Powered Device and Battery Wiring41
Telephone Communications44
- B430 Plug-In Communicator, Telephone44
- Supervision44
- Installation and Module Wiring (B430)44
- Diagnostic Leds45
- Phone Jack Location45
- Telephone Line Monitor46
- Called Party Disconnect46
- Communication Failure47
IP Communications48
- On-Board Ethernet Connection48
- Supervision48
- Local Programming48
- On-Board Ethernet Diagnostic Leds49
- Conettix Plug-In Cellular Modules50
- B426 Ethernet Communication Module50
- Address and Emulation Settings50
- Supervision50
- B426 Module Faults51
- Installation and Control Panel Wiring (B426)51
- Diagnostic Leds52
- Local Programming53
- B450 Conettix Plug-In Communicator Interface54
- SDI2 Address Settings54
- Supervision54
- Installation and Control Panel Wiring (B450)54
- Diagnostic Leds55
- Compatible Receivers for IP Communication56
Keypads, Keyswitches, Keyfobs and Transmitters58
- Keypads58
- Keypads Overview58
- B921C Two-Line Capacitive Keypad with Inputs59
- Shortcuts and Custom Functions59
- Address Settings60
- Supervision60
- Installation and Control Panel Wiring (Keypads)60
- Sensor Loops Overview and Wiring (B921C/B942/B942W Only)61
- Output Wiring (B942/B942W Only)62
- Troubleshooting62
- Keyswitches62
- Operation63
- Installation and Control Panel Wiring (Keyswitches)63
- RADION Keyfobs and Inovonics Pendant Transmitters64
On-Board Outputs65
- Circuit Protection65
- Total Available Power65
- Continuous Power Outputs66
- Programmable Power Outputs66
- Terminals 6 and 766
- Terminal 867
- USB Power67
Off-Board Outputs68
- B308 Octo-Output Module68
- SDI2 Address Settings68
- Supervision68
- Installation and Control Panel Wiring (B308)69
- B600 Retrofit ZONEX Module69
- Installation and Control Panel Wiring (B600)70
- D8129 Octo-Relay Module71
On-Board Points72
- Point Sensor Loops72
- Single EOL (and no EOL) Resistor Circuit Style72
- Dual EOL Resistor Circuit Style73
- Point Response Time74
Off-Board Points75
- B208 Octo-Input Module75
- SDI2 Address Settings75
- Supervision75
- Installation and Control Panel Wiring (B208)75
- Sensor Loops Overview and Wiring77
- B299 POPEX Module79
- SDI2 Address Settings79
- Supervision79
- Installation and Control Panel Wiring (B299)80
- POPIT Devices Overview and Wiring80
- B600 Retrofit ZONEX Module81
- Installation and Control Panel Wiring (B600)81
- D8125 Expansion82
- D8128D Octopopit Eight-Point Expander83
- Off-Board Points Test84
- Extra Point Events84
- Missing Point Conditions84
Wireless Modules85
- B810 Receiver85
- SDI2 Address Settings85
- Supervision85
- Installation and Control Panel Wiring (B810)85
- B820 SDI2 Inovonics Interface Module86
- SDI2 Address Settings86
- Supervision86
- Installation and Control Panel Wiring (B820)86
Access Control88
- B901 Door Controller88
- Address Settings88
- Supervision88
- Installation and Control Panel Wiring (B901)89
- D9210C Access Control Interface Module89
- Card Reader Wiring90
Program and Test the Control Panel91
- Program the Control Panel91
- Program the Control Panel with RPS91
- Program the Control Panel with the Installer Services Portal Programming Tool92
- Program the Control Panel with a Keypad92
- Walk Tests92
- Fire Walk Test92
- Intrusion Walk Test93
- Service Walk Test93
- Invisible Walk Test94
Control Panel Board Overview95
System Wiring Diagrams97
- Power Supply Side Wiring98
- Input Points Wiring with D125B, D130, or D12999
- Input Points Wiring with or Without EOL Resistors99
- SDI and ZONEX Wiring100
- SDI2 Devices General System Wiring102
- SDI2 Bus Wiring Recommendations102
- 2-Wire Smoke Wiring (D125B)104
Approved Applications106
- Optional Compatible Equipment106
- Burglar Applications106
- Bank Safe and Vault Applications106
- Fire Applications109
- Enclosures111
- Combination Fire and Intrusion Alarm Systems111
- Compatible UL Listed Components111
- Standby Battery Requirements and Calculations114
- Household Fire Warning Equipment117
- UL 365 - Police Station Connected Burglar Alarm Units and Systems118
- UL 636 - Holdup Alarm Units and System118
- Required Programming to Meet UL 864118
- Required Values to Achieve 180S (Ulc)/200S (UL) Supervision Interval122
- Ulc122
Keypad Installer Menu123
- Program Menu (Programming)130
- Reporting > [1] Phone Menu Parameters130
- Reporting > [2] Network Menu Parameters131
- Reporting > [3] Routing Menu Parameters132
- Reporting > [4] Personal Note Menu Parameters133
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [1] Module135
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [2] Address136
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [3] DNS137
- Network > [2] Cellular > (Choose the SDI2 Cellular Module or Plug-In Module)137
- RPS > [1] RPS Passcode Menu Parameters138
- RPS > [2] RPS Phone Number Menu Parameters139
- RPS > [3] RPS IP Address Menu Parameters139
- RPS > [4] RPS Port Number Menu Parameters139
- Area Options Menu Parameters140
- Keypad Menu Parameters141
- Users Menu Parameters144
- Points Menu Parameters144
- Disable Programming Menu152
- Wireless Menu152
- RF Point Menu> [1] Enroll Point RFID152
- RF Point Menu> [2] Replace Point RFID153
- RF Point Menu> [3] Remove Point RFID153
- RF Repeater Menu > [1] Add Repeater153
- RF Repeater Menu > [2] Replace Repeater154
- RF Repeater Menu > [3] Remove Repeater154
- RF Diagnostic Menu > [1] RF Points154
- RF Diagnostic Menu > [2] RF Repeater Menu155
- Diags Menu155
- Wireless155
- Network Menu155
- Cellular Menu156
- IP Camera156
- Cloud156
- Service Bypass (Serv Byp) Menu157
- Versions Menu157
- Cloud Menu158
- USB Power158
Specifications159
- Wire Requirements160
Appendix163
- Address Settings163
- B208 Address Settings163
- B299 Address Settings165
- B308 Address Settings165
- D8128D Address Settings167
- D8129 Address Settings168
- B901 Address Settings168
- B91X Address Settings168
- D9210C Address Settings169
- SDI Keypad Address Settings170
- Reporting and Device Number Information171
- Report Format Definitions171
- Device Numbers (Zzz, DDDD)180
- Communication Trouble Device Numbers (Zzzz)181
- Special User Ids (Uuuu, IIII)181
- Keypad Alarm Virtual Point Numbers (Ppp, Pppp)182
- Autoip182

Related product manuals

Preview: Bosch B9512G

Preview: Bosch B5512

Preview: Bosch B6512

Preview: Bosch B8512G

Preview: Bosch MPC-xxxx-B

Bosch MPC-xxxx-B

Preview: Bosch FPD-7024

Preview: Bosch D9412GV4

Preview: Bosch 2000 Series

Bosch 2000 Series

Preview: Bosch AVENAR 8000

Bosch AVENAR 8000