Why is my Bosch Kitchen Appliances not showing anything on the display and won't turn on?
If your Bosch Kitchen Appliances displays nothing and won't switch on, the issue is likely a lack of power supply. Check that the appliance is properly plugged into the mains.
What to do if SensorControl Plus on my Bosch Kitchen Appliances cannot be started?
If SensorControl Plus on your Bosch Kitchen Appliance cannot be started and shows “ADD INGREDIENTS” even after adding them, it means the ingredients were added before the scales were activated. Empty the bowl, reselect the program, and only add ingredients after the program is selected and the scales display “0 g” or “0.00 lb” (depending on setting) or “ADD INGREDIENTS”.
What to do if my laundry is caught in the door of my Bosch Washer/Dryer?
If laundry is caught in the door of your Bosch Washer/Dryer, remove any trapped laundry.
How to fix long drying times on my Bosch Washer/Dryer?
If your Bosch Washer/Dryer is taking too long to dry, it could be due to a few factors. If the ambient temperature is greater than 30 °C or there is insufficient air circulation at the appliance's installation location, ventilate the area. Also, if fluff has accumulated in the drum, run the Cottons 90°C programme without any laundry or detergent.
Why Bosch Washer/Dryer spin result is not satisfactory?
If the spin result of your Bosch Washer/Dryer isn't satisfactory and the laundry is too wet, it could be due to a blocked drain pipe or water outlet hose. Clean the drain pipe and the water outlet hose. Also, ensure that the drain pipe or water drain hose isn't caught or jammed. If the unbalanced load detection system has interrupted the spin cycle because the laundry is unevenly distributed, redistribute the laundry in the drum.
How to troubleshoot a Bosch Kitchen Appliance when nothing is shown on the display and the illuminated ring is off?
If nothing is shown on the display and the illuminated ring is off, it means the appliance has no power supply. Check the power supply by plugging the mains plug into the mains.
What to do if my Bosch Kitchen Appliance switches off during use?
Your Bosch Kitchen Appliance might be switching off during use due to several reasons: * Too much food being processed at once or for too long. To resolve this, turn the rotary switch to 'y', disconnect the mains plug, reduce the processing quantity, and allow the appliance to cool down to room temperature. * The swivel arm was opened. To fix this, turn the rotary switch to 'y', press the release button, and push the swivel arm down until it locks into place. * The bowl or bevel gear (accessory) has become loose. To correct this, turn the rotary switch to 'y', disconnect the mains plug, tighten the bowl by turning it until it stops, and tighten the bevel gear and close the locking lever completely.
Why does my Bosch Kitchen Appliance not show weight changes when adding ingredients?
Your Bosch Kitchen Appliance may not show weight changes because the quantity of added ingredients is less than 5 grams (0.01 lb). Add at least 5 grams (0.01 lb) for the scales to provide correct measurements.
What does 'ERROR ARM OPEN' mean on my Bosch Kitchen Appliances and how do I fix it?
If your Bosch Kitchen Appliance shows 'ERROR ARM OPEN', it means the swivel arm was opened. To fix this, turn the rotary switch to 'y', press the release button, and push the swivel arm down until it locks into place.
What does 'OVERLOAD or UNDERLOAD' mean when using SensorControl Plus on my Bosch Kitchen Appliances?
The message 'OVERLOAD or UNDERLOAD' when using SensorControl Plus on your Bosch Kitchen Appliance indicates that too much or too little of the ingredients was added for the selected program. Add ingredients according to the specified quantities.
This document is an instruction manual for a Bosch warming drawer, specifically models BIC630N.1B, BIC630N.1A, and BID630N.1A. The manual provides comprehensive guidance on the safe and correct operation, maintenance, and troubleshooting of the appliance.
The Bosch warming drawer is designed for domestic use, primarily for keeping food warm and preheating plates. It can be used up to a maximum height of 4000 meters above sea level. The appliance features a fan and heating element to ensure even warming.
The warming drawer offers several functions, selectable via a function selector:
An operating indicator light flashes when the appliance is switched on and lights up continuously once the drawer is closed and heating.
Opening and Closing: For appliances without a handle, the drawer is opened or closed by pressing its middle. It pops out slightly, allowing the user to pull it out completely.
Preheating Ovenware: Preheating ovenware helps food stay warm for longer. The drawer can hold up to 25 kg of ovenware. For optimal results, ovenware should be distributed over the entire surface. Tall stacks of plates take longer to warm than individual pieces. The recommended setting for preheating crockery is 4. Drinks containers, such as espresso cups, should always be heated on setting 2 to prevent them from becoming excessively hot and causing injury. Preheating time varies depending on the material, thickness, quantity, and arrangement of the ovenware, typically taking 15-25 minutes for dinnerware for 6 people. Ovenware should be removed using oven gloves or an oven cloth as the heating plate and ovenware bases can become very hot.
Keeping Food Warm: The appliance is suitable for keeping a variety of foods warm, including meat, poultry, fish, sauces, vegetables, side dishes, and soups. To keep food warm, it should be placed in the drawer, and the function selector set to 3. The appliance should be preheated for 10 minutes before adding food. Food should be covered with a heat-resistant lid or aluminum foil to retain warmth and moisture. It is recommended not to keep food warm for longer than an hour. Hot saucepans or pans should not be placed directly on the glass surface immediately after removal from a hot drawer, as this could damage the surface.
Settings Table and Tips: The manual includes a detailed table outlining various uses for each function selector level, along with specific notes. For example:
Slow Cooking: Slow cooking is an ideal method for tender cuts of meat that are to be cooked rare or very rare, resulting in juicy and tender meat. This method offers flexibility in meal planning due to longer cooking times and the ability to keep slow-cooked meat warm easily. Suitable ovenware includes glass, porcelain, or ceramic dishes with a lid, such as a glass roasting dish. The process involves preheating the warming drawer with ovenware at setting 4. Meat is then seared in a pan over high heat, transferred to the warmed ovenware, covered, and placed back in the warming drawer to complete cooking at setting 3. Notes on slow cooking emphasize using high-quality, fresh meat, carefully removing sinews and fat. The meat should not be turned, even large joints. It can be cut immediately after cooking. Slow-cooked meat is not as hot as conventionally cooked meat, so serving with hot sauce is recommended. Plates can be warmed in the drawer for the last 20-30 minutes. Slow-cooked meat can be kept warm for up to 45 minutes for small pieces and up to two hours for large pieces by turning the oven back to setting 2.
Cleaning: The appliance should only be cleaned when switched off (function selector at position 0). High-pressure cleaners or steam jets must not be used.
Appliance Exterior: The exterior should be wiped with water and a mild detergent, then dried with a soft cloth. Caustic or abrasive cleaning products are not suitable. Any contact with such substances on the frontage should be immediately washed off with water.
Stainless Steel Surfaces: Spots of limescale, grease, cornflour, and egg white should be removed immediately to prevent corrosion. Clean with water and a mild detergent, then dry with a soft cloth.
Appliances with Glass Fronts: The glass front should be cleaned with glass cleaner and a soft cloth. A glass scraper should not be used.
Heating Plate: The heating plate can be cleaned using warm water and a little detergent.
Troubleshooting: The manual provides a troubleshooting guide for common issues:
Customer Service: For repairs or advice, users are instructed to provide the full product number (E no.) and production number (FD no.), found on the rating plate when the appliance door is open. Contact details for customer service in Great Britain and Ireland are provided. Users are advised to rely on trained service technicians who use original spare parts.
Environmental Protection: The manual also includes information on environmentally-friendly disposal of packaging and the appliance itself, in accordance with European Directive 2012/19/EU (WEEE).
To Next Page
General