Need help?Do you have a question about the Bosch Climate 5000 AAS-009-0CS and is the answer not in the manual?
General| Cooling Capacity | 2.6 kW |
|---|---|
| Energy Efficiency Class Cooling | A++ |
| Energy Efficiency Class Heating | A+ |
| Refrigerant | R32 |
| Type | Split Air Conditioner |
Explains the meaning of warning symbols and keywords used in the manual.
Provides essential safety precautions for installation and operation to prevent injury or damage.
Details the criteria and restrictions for choosing an appropriate location for the indoor unit.
Provides instructions on how to properly secure the mounting plate to the wall.
Guides on drilling the necessary wall hole for refrigerant piping and cables, including angles.
Instructions for preparing the refrigerant piping for connection through the wall hole.
Explains how to connect and route the drain hose for proper condensate removal.
Details the process of connecting the signal and power cables between units.
Instructions on bundling and insulating refrigerant pipes, drain hose, and cables for safe passage.
Describes how to securely hang and attach the indoor unit to the mounting plate.
Outlines the required clearances and environmental considerations for the outdoor unit location.
Details the installation of the drain joint for condensate removal during heating mode.
Provides instructions for anchoring the outdoor unit securely to a platform or bracket.
Guides on connecting the signal and power cables to the outdoor unit's terminal block.
Covers cutting, removing burrs, and flaring refrigerant pipes for proper connection.
Details the procedure for connecting refrigerant pipes to the indoor unit.
Details the procedure for connecting refrigerant pipes to the outdoor unit's valves.
Advises on necessary preparations and precautions before performing system evacuation.
Provides step-by-step guidance on using a vacuum pump and manifold gauge for system evacuation.
Explains how to calculate and add refrigerant based on pipe length and unit model.
Outlines checks for proper grounding, terminal security, and electrical leakage.
Details methods for checking refrigerant piping for leaks using soap or detector.
Lists checks to perform before starting the unit's test run.
Provides procedures for performing the test run and verifying unit functions.
To Next Page