en How it works
32
ATTENTION!
Metal touching the wall of the cooking compartment
will cause sparks, which may damage the appliance or
the inner door pane.
▶
Metal (e.g. a spoon in a glass) must be kept at least
2cm from the cooking compartment walls and the
inside of the door.
Recommended settings for warming up food using the microwave mode
Food Accessory/cook-
ware
Shelf pos-
ition
Heating
function
→Page10
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Drinks, warming up,
200ml
Uncovered cook-
ware
1 - 1000 1 - 3
1
Baby food, heating up,
e.g. baby bottle, 150ml
Uncovered cook-
ware
1 - 360 1 - 3
1
Vegetables, chilled,
250g
Covered cookware 1 - 600 3 - 8
Side dishes, e.g. pasta,
dumplings, potatoes, rice
Chilled
Covered cookware 1 - 600 5 - 10
Soup, stew, 400ml
Chilled
Covered cookware 1 - 600 5 - 7
Plated meal, 1portion
Chilled
Covered cookware 1 - 600 4 - 8
Bakes, 400g, e.g.
lasagne, potato gratin
Uncovered cook-
ware
1 180 - 200 180 20 -25
Side dishes, 500g, e.g.
pasta, dumplings, pota-
toes, rice
Frozen
Covered cookware 1 - 600 7 - 10
Soup, stew, 200ml
Frozen
Covered cookware 1 - 600 4 - 6
1
Plated meal, 1portion
Frozen
Covered cookware 1 - 600 11 - 15
1
Stir the food well.
22.8 Test dishes
The information in this section is provided for test institutes to facilitate testing of the appliance in accordance with
EN 60350-1:2013 or IEC 60350-1:2011 and EN 60705:2012 or IEC 60705:2010.
Baking
¡ The setting values apply to food that is placed into a
cold cooking compartment.
¡ Please take note of the information on preheating in
the recommended settings tables. These setting val-
ues assume that the rapid heat-up function is not
being used.
¡ For baking, use the lower of the specified temperat-
ures to start with.
¡ Items that are placed in the appliance on baking
trays or in baking tins/dishes at the same time will
not necessarily be ready at the same time.
¡ Shelf positions when baking on 2levels:
– Universal pan: Shelf position3
Baking tray: Shelf position1
¡ Hot water sponge cake
– When baking on two levels, place the springform
tins at diagonally opposite corners of the wire
racks.