en Troubleshooting
50
Fault Cause Troubleshooting
E:3200 or indicator for wa-
ter supply lights up.
5. Remove the filter from the supply
hose
6. Clean the filter.
7. Re-insert the filter in the supply
hose.
8. Screw the water connection back
on.
9. Check the water connection for
leaks.
10. Restore the power supply.
11. Switch the appliance on.
E:3400 lights up. Water is continuously run-
ning into the appliance.
1. Turn off the water tap.
2. Call "Customer Service"
→Page63.
E:6102 lights up. Wastewater pump is
blocked.
▶ Clean the wastewater pump.
→"Clean wastewater pump",
Page62
Cover of the wastewater
pump is loose
▶ Secure the cover of the "Wastewa-
ter pump " →Page62 so it clicks
into position.
E:6103 lights up. Water is
not drained.
Wastewater hose is blocked
or kinked.
1. Reposition the wastewater hose
without kinks.
2. Remove residues.
Siphon connection is still
sealed.
▶ Check the connection to the siphon
and open if necessary.
Cover of the wastewater
pump is loose.
▶ Secure the cover of the "Wastewa-
ter pump " →Page62 so it clicks
into position.
To Next Page
Loading...
Need help?
General