Intelligent dosing system en
45
My water hardness:
Below is an example of detergent
dosages on a packaging label:
The default setting for the basic dosage
is set specifically according to the area
in which you live (e.g. 75 ml for
detergent and 36 ml for fabric softener).
Set the basic detergent dosage
according to the detergent's packaging
label. Take your water hardness into
consideration when doing so.
Select the basic fabric softener dosage
according to how soft you would like
your laundry to be.
Changing one basic dosage affects all
three dosage quantities in the same
way.
Notes
■ Reduce the basic dosage if using a
very concentrated detergent.
■ If large amounts of foam are
repeatedly created during washing,
please check your basic dosage and
dosage quantity settings.
Certain types of liquid detergent can
also create excessive amounts of
foam. If your basic dosage and
dosage quantity settings are correct,
we advise you to use a different
detergent.
Changing the basic dosages:
1. Press the corresponding i-DOS
button (w or i) for approx. 3
seconds. The preset basic dosage
will appear in the display panel.
2. Set the required basic dosage using
the Ready in ñ - or + buttons.
3. The setting is activated without
needing to be confirmed. You can
now wait for a short while or press
any button (except the i-DOS
buttons) to revert to the original
setting.
Note: The settings are saved until
they are changed again, even if the
machine is switched off.
Degree of
soiling →
Water
hardness ↓
light
normal
heavy
very heavy
soft/medium 55 ml 75 ml 120
ml
160
ml
hard/very hard 75 ml 95 ml 150
ml
180
ml
To Next Page
Loading...
Need help?
General