en Cleaning and maintenance
50
i-DOS detergent draw and its
housing
1. Emptying the dispensers:
The dispensers have emptying
outlets with removable sealing plugs
at the front. To empty the
dispensers, first remove the drawer
handle as shown below:
a) Pull out the detergent drawer.
b) Pull the catch (A) on the back of
the drawer handle (in the centre
at the bottom) slightly towards
you. This unlocks the drawer
handle (B), which you can then
pull off by lifting it upwards.
c) To empty the dispensers,
carefully pull off each of the
sealing plugs and empty the
contents into a suitable container.
d) Then push the sealing plugs
back in completely.
2. Cleaning the dispensers/detergent
drawer:
The detergent drawer can be
removed completely to allow you to
clean to dispensers after you have
emptied them.
a) Empty the dispensers before
removing the drawer.
Note: Only put the drawer handle
back on after you have finished
cleaning.
b) Pull out the drawer.
c) Press the catch and remove the
drawer completely.
d) Carefully remove the drawer
cover.
Caution!
Risk of damage to the detergent
drawer.
The detergent drawer contains
electrical components. These may
become damaged if they come into
contact with water.
– Do not clean the cover in the
dishwasher and do not immerse
it in water.
To Next Page
Loading...
Need help?
General