en Operating the appliance
6
1Operating the appliance
Operating the appliance
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
Note: Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel model 1
Setting the fan
Switching on
■ Pull out the filter pull-out and touch the % symbol.
The fan will start at setting 2.
■ Select the fan settings.
Note: When the filter pull-out is pushed in, only fan
settings 1, 2 and 3 can be selected.
Switching off
Touch the % symbol. Slide in the filter pull-out.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Touch the C or D symbol.
After approximately six minutes, the electronics
automatically reduce the fan to a lower setting . If you
want to end the intensive setting before the preset time
expires, touch the symbol for the required fan setting.
Fan run-on time
Touch the y symbol or slide in the filter pull-out while
the extractor hood is operating.
After approximately 10 minutes, the fan will switch off
automatically.
Saturation display
When the metal grease filters are saturated, an audible
signal sounds for approximately four seconds after the
fan is switched off.
The indicator above the E symbol flashes as well.
If you have not yet done so, the metal grease filters
should now be cleaned.
For instructions on how to clean the metal grease filters,
please refer to the section: Cleaning and maintenance.
The saturation indicator can be reset while it is flashing.
To do this, touch the E symbol.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the B symbol.
Setting the brightness
Press and hold the B symbol until the required
brightness is reached.
Audible signal
Switching on the audible signal
Touch and hold the # and C symbols at the
same time for approximately three seconds when the
fan is switched off. An audible signal sounds as an
acknowledgement.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
ERRVW
SRZHU
ERRVW
Explanation
#
Fan on/off
1-3 Fan settings
C
Intensive setting 1
D
Intensive setting 2
%
Fan run-on
E
Metal grease filter saturation indicator
B
Light on/off/dimming
To Next Page
Loading...
Need help?
General