HomeConnect en
39
Navigating in the HomeConnect
menu
▶ Briefly press Remote Start until
the display shows the required set-
ting.
Exiting the HomeConnect menu
▶ Press and hold Remote Start for
at least 3seconds.
17.4 Activating Wi-Fi on the
appliance
Requirements
¡ The HomeConnect menu is called
up. →Page38
¡ The display shows "oFF".
▶ Press to change the setting.
a The display shows "on" if the Wi-Fi
is activated.
Note:If the Wi-Fi is activated, the dis-
play alternately shows "on" and the
signal strength of the Wi-Fi connec-
tion.
17.5 Deactivating Wi-Fi on the
appliance
Requirements
¡ The HomeConnect menu is called
up. →Page38
¡ The display shows "on".
▶ Press to change the setting.
a The display shows "oFF" if the Wi-
Fi is deactivated.
17.6 Resetting the appliance
network settings
Requirements
¡ The HomeConnect menu is called
up. →Page38
¡ The display shows "rES".
▶ Press and hold for at least
3seconds.
a The network settings are reset.
17.7 Remote start
Enable the appliance for remote start
via the HomeConnect app.
Note
Remote start will be deactivated in
the following circumstances:
¡ The appliance door is opened.
¡ Following a power cut.
Activating remote start
Requirements
¡ The appliance door is closed.
¡ The detergent drawer has been
pushed in.
▶ Press Remote Start.
a Remote Start lights up and the
appliance is enabled for remote
start via the HomeConnect app.
Deactivating remote start
▶ Press Remote Start.
a Remote Start goes out.
17.8 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the HomeConnect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
To Next Page
Loading...
Need help?
General
