Sabbath mode en
21
14 Sabbath mode
You can set a cooking time of up to 74hours using
Sabbath mode. You can use top/bottom heating to
keep food warm between 85°C and 140°C during
this time without having to switch the appliance on or
off.
14.1 Starting Sabbath mode
Notes
¡ If you open the appliance door during operation, the
appliance stops heating. When you close the appli-
ance door, the appliance continues to heat again.
¡ Once it has started, you can no longer change or in-
terrupt Sabbath mode.
Requirements
¡ Sabbath mode is activated in the basic settings.
→"Basic settings", Page21
¡ The operating mode "Types of heating" has been
selected.
1.
Press "Sabbath mode".
If you cannot see the type of heating in the touch
displays, use the control ring to scroll though the se-
lection list.
a The temperature is highlighted in white.
2.
Use the control ring to set the temperature.
3.
Press "Cooking time".
4.
Use the control ring to set the cooking time.
The end time cannot be delayed.
5.
Press to start the operation.
a The appliance starts to heat and the time starts to
count down.
6.
Once the cooking time has elapsed, an audible sig-
nal sounds. The cooking time is at zero. The appli-
ance stops heating up and responds again as usual
outside of Sabbath mode.
‒ Press to switch the appliance off.
The appliance automatically switches off after ap-
prox.10to 20 minutes.
15 Basic settings
You can configure the appliance to meet your needs.
15.1 Overview of the basic settings
Here you can find an overview of the basic settings
and factory settings. The basic settings depend on the
features of your appliance.
Basic setting Selection
Language See selection on the appli-
ance.
Clock Clock in 24-hour format.
Water hardness
→"Before using for the
first time", Page12
00 (softened)
01 (soft)
02 (med.)
03 (hard)
04 (very hard)
1
Home Connect HomeConnect Settings
→"HomeConnect ",
Page22
Factory setting Reset
Do not reset
1
Audible signal Short duration (30 seconds)
Medium duration (1 minute)
1
Long duration (5 minutes)
Volume 5 settings
Button tone Switched on
Switched off (tone remains
for )
1
Display brightness 5 settings
Clock display Off
Digital
1
Analogue
Lighting Off during operation
On during operation
1
1
Factory setting (may vary according to model)
Basic setting Selection
Operation after switch-
on
Main menu
Types of heating
1
Steam
Assist
Night-time dimming Switched off
1
Switched on
Brand logo Display
1
Do not display
Fan run-on time Recommended
1
Minimum
Pull-out system Not retrofitted (if shelf sup-
ports and a single set of
pull-out rails are fitted)
1
Retrofitted (if two or three
sets of pull-out rails are fit-
ted)
Sabbath mode Switched on
Switched off
1
1
Factory setting (may vary according to model)
15.2 Changing the basic settings
Requirement:The appliance is switched on.
1.
Press .
2.
Press "Basic settings".
3.
Press the required basic setting and use the control
ring to change it.
The red bar next to the text field identifies the basic
setting that is currently selected. Its corresponding
value is shown in the display.
4.
Use"Further settings" to scroll through the basic
settings and, if required, usethe control ring to
change any of these settings.
5.
To save your changes, press and use "Save"
to confirm.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
