43
en
Initial use
F
It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run.
The preset water hardness is level 4.
If a water softener is installed in the
house, please set the water hard-
ness to level 3. You can also check
the water hardness by asking your
local water supplier.
■ Use the enclosed test strip to determine
the water hardness. Briey dip the test
strip in water and check the result after
one minute�
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
■ Turn the control ring with you nger to set
the water hardness determined.
■ [ Home Connect ] appears on the left and
on the right [ Set-up complete]�
■ To now connect the appliance to the
WLAN network (home network), touch
[ Home Connect ]�
■ To connect the appliance to the WLAN
network later on, touch [ Set-up complete]�
The settings for Language and Water
hardness are saved�
F
When selecting [ Home Connect ]
please read the detailed description
in the section “Home Connect”.
The appliance is ready to use as soon
as the drink symbols are shown and the
m lights up.
The integrated fan switches on each time
a drink is dispensed and switches o again
after a few minutes.
When the appliance is used for the rst time
after running a service program, or if it has
not been operated for a long period, the rst
beverage will not have the full aroma and
should not be consumed.
When the fully automatic coee machine
is rst used, a suitably thick and stable
“crema” is only achieved after the rst few
cups have been dispensed�
Switch o appliance
■ Press I�
The appliance rinses and switches to
energy saving mode.
Exception: If only hot water is dispensed,
the appliance switches o without rinsing .
■ To switch the appliance o completely,
open the appliance door and set the
mains switch to h�
F
Important: Do not press the mains
switch while the appliance is in use.
Switch off the appliance only when
it is in energy saving mode, so it can
rinse automatically.
The factory settings of the fully
automatic coffee machine are pro-
grammed for optimal performance.
The appliances switches automat-
ically to the energy saving mode
after a congured time and rinses
(duration can be set, see “Switch o
after” in the section “Menu”).
The appliance is equipped with a
sensor. If there is a milk container,
this will be correspondingly shown
on the display when switching to the
energy saving mode. If there is milk
in the container, please keep in the
fridge�
To Next Page
Loading...
Need help?
General
