48
en Preparation using ground coee
The milk is dispensed into the cup or glass
rst. Then the coee is brewed and runs
into the cup or glass.
Press C again to stop the current step of
the process prematurely.
Milk froth or warm milk
■ Place a cup or glass underneath the
beverage outlet.
■ Turn the control ring and select
“Milkfroth” or “Warm milk”�
F
The settings can be changed as
described in the section “Drink
adjustment”.
■ Press C to start dispensing�
Milk froth or warm milk is dispensed from
the beverage outlet.
Press C again to prematurely halt the
dispensing process�
Preparation using
ground coee
F
When using ground coffee, the
setting for the strength of the coffee
and dispensing two cups at once is
not available.
Important: Remove cups or
glasses before opening the door
in case they fall.
The appliance must be ready for use.
■ Open the appliance door.
■ Remove the ground coee drawer.
The removable drawer must be dry.
■ Put in coee powder (maximum 2 level
measuring spoons); do not press rmly.
F
Caution!
Do not use whole beans or instant
coee.
■ Replace the ground coee drawer.
■ Close the appliance door.
F
If coffee is not dispensed within
90 seconds, the brewing chamber
empties automatically to avoid an
overflow. The appliance is then
rinsed�
■ Place a cup underneath the beverage
outlet.
■ Turn the control ring and select a coee
drink or a coee drink with milk.
The display shows the selected drink, a
measuring spoon and the preset values for
this drink.
F
The settings can be changed as
described in the section “Drink
adjustment”.
For coffee drinks with milk, please
observe the instructions in the
section “Preparation using milk”.
■ Press C to start dispensing�
The coee is brewed and then dispensed
into the cup. When selecting coee drinks
with milk, the milk is rst dispensed and
then the coee brewed.
F
For another drink with ground coffee,
repeat the procedure�
Dispensing hot water
B
Risk of burns!
The beverage outlet gets very hot.
After use, always let it cool down
before you touch it.
The appliance must be ready for use.
■ Remove the milk tube from the milk
container�
■ Remove any milk or coee residue from
the outlet.
■ Place a cup or glass underneath the
beverage outlet.
■ Turn the control ring and select
“Hotwater”�
F
The settings can be changed as
described in the section “Drink
adjustment”.
■ Press C to start dispensing�
■ The message appears “Milk hose
separated from milk container?”�
■ If still connected, remove the milk tube
and touch [ Yes ] on the display.
Hot water ows out of the beverage outlet.
Press C again to prematurely halt the
dispensing process�