To Next PageTo Next PageWhy did water drip when I removed the drip tray from my Bosch Coffee Maker?
If water dripped onto the inner floor of your Bosch Coffee Maker when you removed the drip tray, it's likely because the drip tray was removed too soon. Wait a few seconds after the last drink was dispensed before removing the drip tray.
What to do if my Bosch CTL636ES6 drinks cannot be dispensed?
If your Bosch Coffee Maker isn't dispensing drinks, the beverage outlet or one of the three connections might be blocked. You should clean the beverage outlet and the connections to resolve this issue.
Why does my Bosch Coffee Maker display “Empty drip trays” when they are empty?
If your Bosch Coffee Maker displays “Empty drip trays” even when they are empty, it could be because the drip tray is soiled and wet; clean and dry it thoroughly. Alternatively, the emptying may not be detected when the appliance is switched off; try removing and re-inserting the drip tray while the appliance is switched on.
Why is my Bosch Coffee Maker not frothing milk properly?
If your Bosch Coffee Maker is producing too little milk froth, none at all, or the milk system isn't taking in any milk, several factors could be the cause: * Limescale build-up in the appliance; descale according to instructions. * A blocked beverage outlet or connections; clean these parts. * Unsuitable milk; use cold milk with at least 1.5% fat content that hasn't been boiled. * Incorrectly assembled beverage outlet or milk tubes; moisten and reassemble the parts. * A blocked suction pipe; clean the suction pipe.
Why is my Bosch Coffee Maker not dispensing the full amount of coffee?
If the personally selected volume isn't reached and coffee dispensing slows or stops completely in your Bosch Coffee Maker, it might be due to coffee ground too finely or pre-ground coffee being too fine. Adjust the grinding level to a coarser setting or use coarser ground coffee. It could also be due to limescale build-up, so descale the appliance. Another possible reason is a soiled brewing unit, which should be cleaned.
Why are the coffee grounds not compact and too wet in my Bosch CTL636ES6?
If the coffee grounds from your Bosch Coffee Maker are not compact and are too wet, the grinding setting might be too fine or too coarse, or not enough ground coffee has been used. Adjust the grinding unit to a coarser or finer setting, or use 2 level measuring spoons of ground coffee.
Why doesn't the water filter stay in position in my Bosch CTL636ES6?
If the water filter does not stay in position in the water tank of your Bosch Coffee Maker, it is likely not mounted correctly. Firmly press the water filter straight down into the tank connection.
Why does the bean container stick when inserting it into my Bosch CTL636ES6 Coffee Maker?
If the bean container sticks when you try to insert it into your Bosch Coffee Maker, there are likely beans in the housing. Remove the beans to allow smooth insertion.
Why does the hot water from my Bosch Coffee Maker taste like coffee?
If the hot water from your Bosch Coffee Maker is milky or tastes of coffee, it could be because the milk tube hasn't been removed from the milk container; remove it. Alternatively, there might be milk or coffee residue in the beverage outlet; clean the outlet.
Why does my Bosch Coffee Maker make coffee that is too weak?
If the coffee from your Bosch Coffee Maker is too “weak”, it could be because the selected coffee strength is too weak; increase the strength. Alternatively, ground coffee might be jammed in the coffee drawer; remove the drawer, clean, and dry it thoroughly.
General| Product type | Espresso machine |
|---|---|
| Built-in grinder | Yes |
| Capacity in cups | - cups |
| Milk adding type | Automatic |
| Number of spouts | 1 |
| Coffee input type | Coffee beans |
| Coffee maker type | Fully-auto |
| Appliance placement | Built-in |
| Water tank capacity | 2.4 L |
| Coffee beans capacity | 500 g |
| Maximum operating pressure | 19 bar |
| Reservoir for brewed coffee | - |
| Cord length | 1.7 m |
| Display type | TFT |
| Product color | Black, Stainless steel |
| AC input voltage | 220–240 V |
| AC input frequency | 50 - 60 Hz |
| Package depth | 670 mm |
| Package width | 475 mm |
| Package height | 545 mm |
| Package weight | 22420 g |
Weight and Dimensions| Depth | 375 mm |
|---|---|
| Width | 594 mm |
| Height | 455 mm |
| Weight | 19440 g |
| Installation compartment depth | 356 mm |
| Installation compartment width | 558 mm |
| Installation compartment height | 449 mm |
Explains manual navigation and symbols for understanding the document.
Explains how display texts are presented within the manual.
Explains how buttons and controls are presented in the manual.
Details about the appliance door and its parts.
Explains the main control interface and touch panel.
Describes the power switch function.
Basic requirements, initial setup, and control guide.
Describes information display and touch controls.
Notes for specific hot water dispensing scenarios.
Information shown on the control panel and action prompts.
General guidance on using controls.
How to select and customize drink settings like strength and volume.
Details on temperature, two cups, Aroma Double Shot, and volume.
Information about the milk container.
How to enter, change, and delete saved drink settings.
How to choose and prepare saved drinks.
Guide to menu interaction, settings, and language.
Instructions for filter installation and replacement.
Guides installation and connection of the Home Connect app.
Explains automatic and manual WLAN connection.
How to manage Wi-Fi and adapt Home Connect features.
Disconnecting, app connection, remote start, device info, and data protection.
Adjusts auto-shutoff, display brightness, and key tones.
Instructions for cleaning drip tray, grounds container, and components.
Lists parts suitable for dishwasher cleaning.
Procedures for rinsing and manual cleaning the milk system.
Notifications for descaling, cleaning, Calc'nClean, and safety advice.
