Why can't I insert the brewing unit into my Bosch CTL636E 6?
If the brewing unit of your Bosch Coffee Maker cannot be inserted, it could be in the wrong position or locked. Insert the brewing unit according to the instructions, or unlock the brewing unit.
Why does my Bosch CTL636E 6 say "Clean brewing unit"?
If your Bosch Coffee Maker display shows “Clean brewing unit”, it means that the brewing unit is soiled, there is too much ground coffee in the brewing unit, or the mechanism of the brewing unit is stiff. In this case, clean the brewing unit and do not place more than two level measuring spoons of ground coffee in the drawer.
How to secure the water filter in my Bosch CTL636E 6?
If the water filter does not stay in position in the water tank of your Bosch Coffee Maker, it is likely that the water filter is not mounted correctly. Firmly press the water filter straight down into the tank connection.
Why does my Bosch CTL636E 6 Coffee Maker need descaling so often?
If you see very frequent display that descaling is necessary on your Bosch Coffee Maker, it means that the water is too hard. Insert water filter and configure settings accordingly in the menu.
Why is there water under the drip tray of my Bosch Coffee Maker?
If there is water under the drip tray of your Bosch Coffee Maker, this water is condensed. Do not insert drip tray without cover.
What to do if my Bosch CTL636E 6 Coffee Maker displays "Leave device to cool"?
If your Bosch Coffee Maker display shows “Leave device to cool“, it means the appliance is too hot. Switch off appliance for 30 minutes.
Why does my Bosch CTL636E 6 say "Insert drip trays" when they are inserted?
If the display of your Bosch Coffee Maker shows “Insert drip trays” even though drip tray in use, it could be that the inside of appliance (tray holder) is dirty or the coffee grounds container is not fully inserted. Clean the inside and push the coffee grounds container all the way in.
How to fix weak coffee from Bosch Coffee Maker?
If the coffee from your Bosch Coffee Maker is too “weak”, it could be because the coffee strength selected is too weak or ground coffee is jammed in the coffee drawer. Raise the strength of the coffee or remove the ground coffee drawer, clean and dry thoroughly.
Why does my Bosch CTL636E 6 say "Fill bean container" when it is full?
If your Bosch Coffee Maker display shows “Fill bean container” although the container is already full, or the grinder is not grinding any beans, it might be that beans are not falling into the grinding unit (beans too oily). Try gently tapping the bean container, and possibly change the type of coffee. When the bean container is empty, wipe it with a dry cloth.
What to do if my Bosch CTL636E 6 displays "Refill with still water or remove filter"?
If your Bosch Coffee Maker display shows “Refill with still water or remove filter”, it could be due to several reasons: * The water tank is wrongly inserted. * There is carbonated water in the water tank. * The float is stuck in the water tank. * The new water filter was not rinsed according to instructions, or the water filter is used or defective. * There is air in the water filter. To resolve this, insert the water tank correctly, fill the water tank with fresh tap water, remove the tank and clean thoroughly, rinse the water filter according to the instructions and then switch on, or use a new water filter, dip the water filter into water until no more air bubbles escape, replace the filter.
General| Type | Automatic Coffee Machine |
|---|---|
| Series | 6 Series |
| Model | CTL636E |
| Coffee Bean Container Capacity | 300 grams |
| Display | Yes |
| Pump pressure | 15 bar |
| Milk system | Integrated milk frother |
| Color | Stainless Steel |
| Programmable | Yes |
| Coffee Preparation | Espresso, Coffee, Cappuccino, Latte Macchiato |
| Water Tank Capacity | 1.7 liters |
| Power | 1600 W |
| Power Consumption | 1600 W |
Safety warnings regarding electrical hazards and proper connection.
Warning about permanent magnets affecting electronic implants.
Safety advice concerning packaging material and small parts.
Precautions to avoid injury during operation, e.g., grinding unit.
Warnings about hot beverage outlets and surfaces.
Warning about potential scalding during unattended remote start.
Precautions regarding appliance heat and cupboard door operation.
Adjust coffee strength, temperature, and quantity.
Steps to prepare coffee using whole beans.
Prepare coffee drinks with milk, milk froth, or warm milk.
Steps for preparing coffee using ground coffee.
Instructions for dispensing hot water.
Instructions for inserting, replacing, or removing the water filter.
Setup for automatic or manual connection to Wi-Fi.
Enable or disable the appliance's Wi-Fi function as needed.
Steps to connect the appliance to your WLAN network.
Activate remote start functionality for app control.
View network and appliance identification details.
Detailed steps for manually cleaning the milk system components.
Instructions for removing and cleaning the brewing unit.
Procedure for removing limescale buildup from the appliance.
Steps to perform a general cleaning cycle for the appliance.
Combines descaling and cleaning processes for comprehensive maintenance.
To Next Page